Electronics Forum | Mon Feb 19 11:25:07 EST 2001 | markt
I am currently cleaning solder paste and adhesive stencils and misprinted substrates manually by using IPA, chem wipes, Q-tips, etc. Can you recommend a machine and chemistry that will clean all these applications?
Electronics Forum | Thu Oct 22 11:11:58 EDT 1998 | Hon
Dear all, What are your views on reworking BGA's? I mean, with the BGA going through reflow temperatures four times or more, and with a manual reballing process, wouldn't it raise up a few reliability issues? Would you consider not doing rework on
Electronics Forum | Mon Mar 03 09:27:19 EST 2003 | floydl
With regard to measuring dot diameter on my dispensers, is there an easier way to calculate the Cp and Cpk values? This manual data crunching is for the birds!
Electronics Forum | Wed Oct 01 10:12:58 EDT 2003 | russ
Call Samsung and see if they have a theory of operation. Otherwise the manuals have a lot of info in them as to how they work. Russ
Electronics Forum | Thu Apr 07 14:11:33 EDT 2022 | SMTA-69080803
@Stephen How big was the adapter board? It's challenging to depanelize and tedious to manually put these tiny assemblies in a tray.
Electronics Forum | Thu Mar 13 01:42:58 EDT 2008 | Sean
Thanks Real Chunks and Davef...Yours input is valuable to me. My inputs towards your question asked below: Questions are: * Why did you tell us the following? "This BGA is installed with heatsink (with hook at both side of the heat sink) manually b
Electronics Forum | Mon Feb 11 13:41:12 EST 2008 | sliebl
We use EFD pneumatic dispensers. Several are second hand from our favorite online auction site. I just checked on there and there are 3 units currently less than $50. Have the bean counters where you work get you one. Tell them your hand hurts from u
Electronics Forum | Mon May 15 13:55:00 EDT 2000 | Aldo
We are in the process of researching manual or low cost automatic Tape and Reel equipment. I have heard about V-tek and Systemation. I would appreciate if someone can tell me any problems or virtues of theses two brands that have been experienced. Al
Electronics Forum | Wed Mar 12 07:33:40 EDT 2008 | callckq
Hi All, One PCBA failed test after went through the Shock Test(Vibration) and suspected to be BGA solder ball crack. We performed dye and pry and found PCB's pad lifted with red mark ink penetrate pad underneath, what does this mean? Can I say the
Electronics Forum | Wed Mar 12 23:00:10 EDT 2008 | davef
You can say: The pad was lifted after reflow and prior to the dye and pry failure analysis. When we see lifted pads, we think: * That's a good solder connection * Either it took a lot of force to lift that pad or the fabrication of the board in the
