Electronics Forum | Tue Apr 16 09:46:36 EDT 2019 | ttheis
We just bought a MVP Supra M machine and have put it under power but can not get the PC system to power on. I am following the power up procedure in the manual. Under power the conveyor controls work and the UPS backup turns on, but holding the key i
Electronics Forum | Sun Jul 09 09:54:21 EDT 2023 | recard
Hi guys. Maybe it helps someone. We solved almost all issues on our machine with changing the capacitors arround the processor on our motherboard. We first suspect the Power supply and decided to use two power supplies, one for the MB and the other o
Electronics Forum | Tue Oct 01 18:44:24 EDT 2013 | richardconnell
Hi, I have limited capability on the Z axis. The axis will home to the mechanical switch limit and then drop to a point which I asssume to be the fiorst zero point below the mechanical switch limit. Then it gives the error. There is power to the mo
Electronics Forum | Tue Oct 17 08:05:22 EDT 2023 | unsung
I don't see your email in my inbox sir. It's a lot to write. Check all your power supplies make sure all of them light up in your machine and Check the Main Start Switch if it correctly works the ignition green button switch you should here a thumb n
Electronics Forum | Thu Feb 06 12:32:24 EST 2014 | gnus
Hi all, During our last production run, our MyData TP9 machine shut down on its own mid assembly. Screen went blank. I turned off the power switch and waited 10mins before trying to power it up again. I turn the switch on and hear the fan turning on
Electronics Forum | Thu Jun 25 21:06:38 EDT 2020 | jshepard77
I have an old Quad 100 pick and place from the 90's that currently is not working. We bought the machine for basically nothing. The reason we bought it was that it had a ton of feeders that work with a 4000C machine that we have. Before I take thi
Electronics Forum | Fri Aug 28 12:46:04 EDT 2020 | inspiredmorris20
Greetings all, my cp45 pnp machine is down this morning, gives me the code 0002 (front EME switch pressed). operator said they did not E-Stop, reset the unit and reboot the S/W a few times. the code pops up as soon as the software loads. I can turn
Electronics Forum | Wed Sep 22 13:49:47 EDT 1999 | Claude Couture
The machine is a Universal 6796 DIP inserter. The driver card for the X axis burned a couple of resistors and a trace, probably a couple of power transistors too. I had a spare card and put it in. Now on powering-up the machine, the X-Y table move
Electronics Forum | Tue Nov 24 13:37:27 EST 2015 | ttheis
A shot of the screen is attached showing the version information. Where do I find the filters? It looks like the power goes from the switch to the large power distribution box which I presume has the back-up batteries inside. What method is recomme
Electronics Forum | Mon Dec 06 21:07:36 EST 2021 | victorzubashev
Hi, you have flickering that affects all AC power in the machine (PC is also connected to the AC line (after step down transformer)), correct? Do you intermittently/randomly lose power in all machines units(MC/PS/Servo)? If I understood you correctly