Electronics Forum | Tue Jun 14 16:23:22 EDT 2022 | glasscake
Cant put a finger on it being an encoder that was just a single possibility. You can always hook up a scope to the encoder and see if they are working appropriately. I would look through the machine's utilities and see if there is some debug or more
Electronics Forum | Sun Apr 04 14:59:38 EDT 2004 | davef
When you say, "you can see the plating of each lead embedded in the broken solder joint", we do not get the sense of a well soldered connection. * We don't expect to see [or make the distinction] of the plating from the connector in the solder. We
Electronics Forum | Thu Nov 18 14:38:59 EST 2004 | EED
There is a couple of things to check. Put the machine in diagnostics and let the chain run. You should see it run the same as you would if purging it. Sometimes the 2 hall effects at the disk do not see the disk as it turns. Check the driver board
Electronics Forum | Tue May 09 14:23:40 EDT 2006 | flipit
I would like to know what you are seeing in production. I have read the papers that state fewer tombstones with SAC305 as well as the papers that state more tombstones with SAC305. I am seeing more tombstones with SAC305. I place a lot of 0402 com
Electronics Forum | Thu Apr 12 04:17:08 EDT 2018 | buckcho
Diego, I dont know how this machine works. Maybe they patented some way of measuring. But the idea of Mr. Evtimov is very good. Measure the pad only and see its value. If it is not 0, you have to know why, maybe ask the machine supplier. Also like Mr
Electronics Forum | Mon Aug 17 02:45:18 EDT 1998 | Bob Willis
| 5 micrograms per sq. cm. is actually not too clean. The maximum military allowed post-clean, on-board contamination is 5.7 micrograms of NaCl /cm squared (when using the Zero-Ion brand ionic contamination tester). | We are use to seeing cleanlines
Electronics Forum | Fri Aug 03 21:08:40 EDT 2001 | Rob Fischer
Good question Dave. Kerry has participated quite a bit in this sort of forum but I have yet to hear whether he is a user or a critic. Check out the Apex exhibitors manual to see all of the vendors that are available or the archives on SMTnet. You
Electronics Forum | Thu Oct 04 13:04:52 EDT 2001 | Hussman
Without seeing your X-ray, it sounds like your BGAs are out gassing. This casues the situation you described. Try baking some BGAs and run them along with ones not baked to see.
Electronics Forum | Sun Jun 02 18:31:58 EDT 2002 | Gregory Hickory
Hi Folks, Well, what I want to see is below: China is good in imitating products. They imitate but they sacrifice the quality. When can I see a Pick-and-place machine that is MADE IN CHINA? With most manufacturers shifting to China....that dream wo
Electronics Forum | Wed May 29 14:36:15 EDT 2002 | blnorman
If you have a specification for the flux, you can retest all the parameters to see if they still comply. Check with Alpha to see if they have a recommendation. Our adhesive suppliers recommend running a lapshear to recertify, so the flux manufactur