Electronics Forum | Wed Feb 01 08:18:28 EST 2006 | slaine
RS sell a heat cun that is fully temperature adjustable buy one of them and pre set it to the right temp then put a calibration sticker over the control.
Electronics Forum | Mon Jun 12 13:10:05 EDT 2006 | muse95
Why do they say to specify the depth of the score, rather than the thickness of the web? How does the scoring equipment work? Is it two blades that you can set the separation distance? Or is it one blade, that you have to run the board through twic
Electronics Forum | Fri Aug 22 15:26:18 EDT 2008 | rway
I rarely use blk fiducials. But when I do, they are always programmed after the fids. It's the fids that sets your general alignment of the panel. I only use blk fidus for thin pcbs (30 mil) that tend to warp when on the conveyor.
Electronics Forum | Thu Oct 30 12:26:26 EDT 2008 | slthomas
Your fridges can't be temperature adjusted? We've always just used "pre-owned" kitchen fridges and set them where we want them.
Electronics Forum | Thu Oct 30 14:30:51 EDT 2008 | jdumont
http://www.bestbuy.com/site/olspage.jsp?skuId=5435031&type=product&id=1149205187587 This is what we have and never had an issue. Its only set to about mid range on the dial and easily holds 40 F.
Electronics Forum | Thu Mar 19 12:26:10 EDT 2020 | yuaanliie
You have mostly set in your mind before purchasing PCB i.e. PCB is an acronym for the printed circuit board. Last month I purchased PCB from Great PCB.
Electronics Forum | Fri May 14 14:46:56 EDT 2021 | emeto
Not following the lead paste process window has a whole set of risks for joints quality and reliability.
Electronics Forum | Thu May 25 18:58:49 EDT 2000 | Mukesh Lad
We are a tape and reel house,we use a variety of machines. If you are looking for low voulume, low cost and easy set up for you operators. I would look at Systemation MT-30, this is a good work-horse, I have used them for 10years for small runs, no
Electronics Forum | Tue Feb 15 00:27:39 EST 2011 | jeffr
First clean and de-bur the hole in the nozzle, then try it again. If the Head does not pick up at the feeder, then moves to the dump position...it means that the Vacuum Sensor Board has detected that the nozzle vacuum is above the LOW threshold setti
Electronics Forum | Fri May 15 12:41:48 EDT 2015 | deanm
I chose a Vitronics XPM3i primarily for the AutoSet automatic profile generation feature. We are high mix and simply cannot profile every board. The AutoSet feature is quick, easy and we rely on it 100% and have great results. These ovens have had ve