Electronics Forum | Tue Jul 17 15:45:22 EDT 2007 | simsj
We've used the Loctite as well. We're currently using Heraeus 955. It's worked well, and it's is less expensive. John S.
Electronics Forum | Tue Jul 17 16:45:27 EDT 2007 | jaimebc
Thank you all for your suggestions, I will get samples of the ones mentioned and give them try. *goes back to listen to Duran Duran*
Electronics Forum | Fri Jul 20 12:13:11 EDT 2007 | hussman
Guess I've been spoiled using Loctite brands for the past 20 years. (Not an advertisement - unless they wanna pay me!)
Electronics Forum | Fri Jul 20 13:21:11 EDT 2007 | realchunks
Hi Huss, Didn't you notice the names, "D Back" and "D Wanzek"? Pretty typical way to start a convo and make it work for yourself.
Electronics Forum | Tue Jul 24 12:34:25 EDT 2007 | jaimebc
Hey Real Chunks, my question was legit, don't use my name to take a shot at someone else.
Electronics Forum | Tue Jul 24 15:13:24 EDT 2007 | adlsmt
I have been using the Heraus paste for almost ten years. At the time we picked it, it and Loctite seemed like the only options. It was a lot less $$ than Loctite. Is there a noticable difference in performance? I think the Loctite was about 2X the pr
Electronics Forum | Thu Jul 26 08:39:16 EDT 2007 | d0min0
since 1999 we use Heraeus PD944, in time we tested Loctite also but had some issues with it - or with our machine specialist :)) we dispense with Fuji CP (2 , 3 & 4) it only creates problems when its on the solder pads ;-) best wishes
Electronics Forum | Thu Jul 19 18:03:14 EDT 2007 | dwanzek
Wait...stop! Some adhesives will void when cured... some common branks... maybe already mentioned. Heraeus PD955 will minimize voiding when curing the adhesive. Voiding can have devestating consequences....learned from experience. Another key is kee
Electronics Forum | Thu Jul 06 07:30:46 EDT 2000 | John
Ralph, Typically our co-op students put down solder paste with a syringe, place the parts on the paste with tweezers, and then reflow the paste with a hot air pencil. This works pretty well when they are hand building prototypes. You can probably
Electronics Forum | Wed Sep 05 10:36:47 EDT 2007 | dwanzek
Hope you found an adhesive that works for you Dback. Thought I felt sharp pain in my back for awhile as did not follow up on this string. Then again, a response may prolong the pain, oh well figured a need for accurate information. FYI for RealHuss
Main Products: 1. Original new and Original Used SMT/AI Spare Parts. 2. SMT Equipments And Related Machine( SMT Calibration, SMT Feeder Carts,Conveyer etc.) 3. Maintenace and Repair Service Pre-Sales Service Provide details ab
Manufacturer's Representative / Manufacturer / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
Building A, Jiepeng Square, Fuyong
Shenzhen, China
Phone: 0755-33578694
