Electronics Forum | Tue Dec 30 04:24:47 EST 2003 | praveen
Hi, Does any body know what is the recommended freqency of Soldering Iron/stations calibration?
Electronics Forum | Wed Apr 03 12:06:49 EDT 2019 | matt
Hey, I'm wondering if anyone has experience with the Metcal CV-5210 soldering iron and if so how has your experience been with this product and the accompanying software? http://www.okinternational.com/CV-5210-Connection-Validation-Soldering-Statio
Electronics Forum | Mon Nov 23 20:16:11 EST 2009 | davef
We're not familiar with Loctite 3606. Adhesive bond strength must be adequate to survive handling forces between the adhesive cure station and the soldering station. At the soldering station, the adhesive will soften during the preheat stage and in
Electronics Forum | Mon Feb 25 09:53:30 EST 2019 | tombstonesmt
Good morning! In order to comply with current IPC J-STD-001G Appendix A-2, I'm putting together a log to periodically monitor solder tip temp tolerance, tip resistance, voltage leakage, etc.. I'm solely focusing on the hand solder stations for the t
Electronics Forum | Mon Sep 13 10:32:31 EDT 2010 | san_1023
I'm going to start up service centre for mobiles. Which soldering station is better to use? Please advise.
Electronics Forum | Thu Jan 22 16:57:26 EST 2004 | davef
A "boffin"!!! How nice to have one of those aboard. Welcome.
Electronics Forum | Wed Jan 28 08:33:24 EST 2004 | Chava
I would like a copy of your document please
Electronics Forum | Tue Mar 12 11:58:19 EDT 2019 | tombstonesmt
Thanks guys! lol
Electronics Forum | Fri Oct 15 11:37:21 EDT 1999 | Ashok Dhawan
I am looking for someone using Wanesco Soldering Station with hole blow-off option installed.I am trying to set it up using hot air. It is provided with special tips with rubber lining to seal off the slected area. But it leaves few holes always bloc
Electronics Forum | Tue Nov 15 16:31:04 EST 2011 | pcbrown
Can anyone tell me if the Metcal SP200 solder station meets the J-STD-001 Rev E requirement of holding a tip temp of +/-9F at rest? I am in a fight with an auditor over this. These irons do not require calibration but I need to know if they meet J-ST