Electronics Forum | Wed Dec 04 15:00:15 EST 2002 | ksfacinelli
I am interested in looking at options for machince calibration and maintenance from a third party provider. The company would have to be up on the servicing of the GEM line of Philips equipment (Emerald / Topaz). Any recommendations??? Kevin
Electronics Forum | Sun Sep 25 16:02:59 EDT 2005 | mark
The calibration was ok. When i switch off the back camera and use front one everything is ok. Is it true that when Topaz use back line camera after checking the components the machine rotates the components 180 degree?. Mark \
Electronics Forum | Wed Feb 16 02:13:13 EST 2011 | vinitverma
Hi Mark, Send me your mail id and I'll send you the very detailed procedure. If you follow to the letter, you'll have a perfectly calibrated machine. You can write to me at vinit.verma@prosemtechnology.com Regards Vinit
Electronics Forum | Tue Jan 09 08:53:48 EST 2018 | pavel_murtishev
Jin, Cloning is possible, but the machine will have to be recalibrated since calibration data from running machine will be copied to failed one. As to back ups. Are you able to get into engineering menu? Regards
Electronics Forum | Tue Feb 12 12:34:54 EST 2019 | compit
Do you have a service manual? There is a description of how to check and CALIBRATE the nozzle sensors (section "Placement Head").
Electronics Forum | Tue Dec 28 07:52:08 EST 2010 | costache
Hello yamaha placement is actualy topaz from Philips, dont know to tell you where to buy one in Sing, but if u have one brocken in site u can take parts from 8mm to put at 16, cose only the width is diffrent, parts inside are about all the same and
Electronics Forum | Tue Feb 12 14:13:56 EST 2019 | aldrich17
We executed that in IO screen all heads went down, N2323 sensor remained 0. And we cannot find N2223 sensor in the I/O screen. So now we are unsure of the issue but we are searching our manual in the "Placement Head" section hoping to come out with a
Electronics Forum | Wed Jun 10 00:34:40 EDT 2015 | vinitverma
I understand from your post that the head does go to the nozzle changer intending to change the nozzle but sometimes it entirely fails to pick up the nozzle and sometimes the nozzle gets picked up a bit but gets stuck in the nozzle changer. This mos
Electronics Forum | Tue Jul 18 11:16:33 EDT 2017 | svfeingold
Found it, it appears to be 15mm. I received a reply from K&S (Kulicke & Soffa) who support the Assembleon machines. They say they do offer full support and training. The support offer is $7,500 per machine for the first year, including: * Annual a
Career Center | ORLANDO, Florida USA | Engineering,Maintenance,Production,Technical Support
Manufacturing tech/eng for a contract manufacture for 10+ years. Been working in the SMT industry for a total of 20yrs. Have done everything from operator to process work. Most familiar with Assembleon, MPM, DEK, BTU,Electrovert, SLIM-KIC, SUPER-MOLE
