Electronics Forum | Wed Sep 01 13:44:42 EDT 1999 | Dave F
| Recently, our solder dross reclaimer refused to take our | used solder paste tubes. He said the small percent of paste | remaining in the tube is now considered hazardous waste. I'm interested in advice on how others are disposing of this "hazardou
Electronics Forum | Thu Feb 05 17:54:04 EST 2004 | davef
Even with the best of intentions, some lots of components just last too long. Recognize that controlled environment storage is only a delaying tactic. So when the piper come to play and baking becomes inevitable, we "repackage" components in tubes
Electronics Forum | Fri Aug 31 12:21:39 EDT 2007 | electronhose
With this length, I would use solid bare wire, solder one end, sleeve with approved shrink tube, solder the other end and shrink the tubing. You could even leave the shrink tube off if you had design clearance. Then you can just trim off the ends on
Electronics Forum | Thu Jan 31 09:07:25 EST 2008 | aj
Hi, we have the same problem here but have a solution. We have Fuji FIP3 machines but this should be the same for all - use the tube that the parts are in for part presentation ! i.e. cut out a window big enough at the top of the tube for the nozzl
Electronics Forum | Wed Sep 10 07:47:47 EDT 2014 | fnorradd
We have just recently purchased a Dage X Ray machine and in transportation the vacuum tube has lost its vacuum. Other than Dage, does anyone know of a company who is capable of re vacuuming the tube to the correct pressure? Any assistance would be
Electronics Forum | Sat Jul 04 05:40:23 EDT 2015 | seshadri
Dear Distingushed Friends, I would like to gain some knowledge on X Ray. It is very Confusing for me to understand the difference between the DAGE Transmissive tube Vs YXLON micro focus tube. The Target power Vs Tube power and detailed detectabilit
Electronics Forum | Sat Aug 28 09:11:38 EDT 1999 | Mike McMonagle
| Recently, our solder dross reclaimer refused to take our | used solder paste tubes. He said the small percent of paste | remaining in the tube is now considered hazardous waste. I'm interested in advice on how others are disposing of this "hazardou
Electronics Forum | Thu Oct 08 14:52:56 EDT 1998 | Dick Casagrande
Anyone know about existing standards on components supplied in tubes? Such as SO8s & SO14s should come in Xmm width tube etc. Right now I have 3 separate SO20W type part numbers coming in 3 different size tubes. Would like to be able to tell my suppl
Electronics Forum | Fri Feb 17 17:23:11 EST 2006 | grantp
Hi, One think we always hated when running MYDATA was the vib feeder, and we had no end of problems. The supplier told us most people angled the component tubes up, however then the vib settings change between when the tubes full, and mostly empty.
.gif)
