Electronics Forum | Fri Sep 08 12:03:24 EDT 2017 | rameshraja
Hi, I need the RF 800 Flux Acid titration procedure and also require EPT of the same to add thinner ( RF 800 additive), i.e we are using the flux rf 800 for our wave soldering process having foam fluxer , after 2 hours we are taking sample from the
Electronics Forum | Mon Oct 27 01:57:12 EDT 2008 | benefon
Hi It appears as if the clincher is not perfectly centered even if it does appear so. You can try to adjust the clincher offset values by entering trial values for the X and Y offsets. Try changing these values in both positive and negative directio
Electronics Forum | Tue Sep 20 15:37:24 EDT 2005 | intermin
Well, at that value point, I'd go with the hourly ( unburdoned ) high-skill rework/repair rate up to 50%-60% of the board value. If this is part of an integrated system ( in-house assembly ) repair to value ratio could go even higher.
Electronics Forum | Sat Mar 10 03:19:34 EST 2018 | Nirmal_Bay
Dear expert`s i am need some information regarding what is different between Impact Value and Placement Force. Normally we only used Placement Force for Pick and Place Machine. Any expert`s can explain for Impact Value? Thank You
Electronics Forum | Thu Jul 25 14:32:55 EDT 2019 | bulur
What does flux acid value means in SMD and PTH applications? Is it higher acid values better for each application?
Electronics Forum | Fri Jun 14 00:47:17 EDT 2013 | mun4o
Thanks , Reese.Yes , I check the capacitors with C-meter.When measured with C-meter , all capacitors are OK - +/-10% of the value. I can not underst?nd "Note: This is not a summation). Y5V -- -20% of nominal value, -part tolerance, -machine toleranc
Electronics Forum | Wed Dec 13 16:12:01 EST 2000 | C Dooley
Is it possible to find the Cpk value for attribute data? We are running into problems due to unspecified LSL/USL values. How can we find the Cpk values without specific LSL/USL? We would also like to get some reference books on this subject so any
Electronics Forum | Wed Sep 22 13:56:24 EDT 2004 | GS
Hello everybody, are this the values still required by RoHS or there have been some modification ? - Maximum concentration Lead (Pb) 0,1 weight% - value of heavy metals Mercury 0,1 weight% - Cadmium 0,01 weight% - Chromium VI 0,1 weight% - Maximum
Electronics Forum | Thu Sep 06 15:41:23 EDT 2012 | rway
This appears to be a non-standard marking. Where did you find this? What is is out of? The 84 may be related to the cap value. Have you tried to measure it? I'm not sure about the "EG" part of it. This marking may be mfg specific, but the stand
Electronics Forum | Thu Jun 28 16:46:30 EDT 2018 | applebar
thank you for the reply it was our error- there was a change notice via a spreadheet in a resistor value; the operator used the old reel/old value. Customer did not pay for AOI. Customer supplied tester passed all the boards, even with the wrong (u