Electronics Forum | Thu Jun 07 10:22:03 EDT 2007 | cokedigits
Man the only ripple i like to see is some fine cognac or hennessey with a 40-oz. as my chaser.
Electronics Forum | Thu Apr 03 13:41:06 EDT 2008 | ratsalad
Hopefully Vitronic's service and support won't turn to complete crap like Kester's did after they bought Kester.
Electronics Forum | Mon Jun 09 16:58:47 EDT 2008 | adamcrum
Does anybody using Vitronic Soltec's Delta 5 wave have any problems with their Select X. Apparently there are others out there (according to our rep) who are having problems. I am curious as to what they are and what you are doing to fix it.
Electronics Forum | Thu Jul 31 02:40:20 EDT 2008 | JH pbf
We use Axarel 2200 as recomended by Vitronics Soltec, which is the same as we use on our MPM printes for under stencil cleaning. It is non-ozone depleating and has a high flash point. For insurance purposes we banned IPA from the shop floor some
Electronics Forum | Sun Sep 13 18:45:24 EDT 2009 | halleyjoan
Is there any possible way to repair the blower of vitronics reflow oven if it stuckup? How to replace its blower? Or i should be replaced as 1 assembly (cell motor and blower assembly).
Electronics Forum | Tue Sep 15 13:02:55 EDT 2009 | horvath83
What do you think about optimal setup for 8-hour working shift and 16-hour standby time. What is the most energy efficient setup for standby time? Complete cooldown or maintaining temperature in solder pot?
Electronics Forum | Wed Sep 16 09:04:12 EDT 2009 | stepheniii
All the heat that comes off the machine comes from powering the machine. The more heat that comes off it, the more energy that went into the machine. When the machine is cold there is no heat energy leaving the machine. Therefore complete cooldown
Electronics Forum | Wed Sep 16 09:29:47 EDT 2009 | patrickbruneel
There has been a thread on the subject in 2007 with record postings. Check here: http://www.smtnet.com/Forums/index.cfm?fuseaction=view_thread&CFApp=1&Thread_ID=11796Message50533
Electronics Forum | Tue Jun 03 10:30:36 EDT 2014 | cbeneat
We have the same ovens, our 2 sided boards have the same profile for both sides. Haven't seen a problem in 8 years.
Electronics Forum | Mon Sep 08 09:11:30 EDT 2014 | jdenuzzia
We resolved this issue a few weeks ago. It was a configuration mismatch in the oven (MR933+)software with the onboard O2 analyzer.