Electronics Forum | Fri Nov 11 18:06:15 EST 2005 | pyramus
Thanks for the reply everybody!!! It is a compact RF device it is currently being designed our R&D is asking some suggestions what kind of shielding would be best for it. It is quite compact that we will be using 0201 chips on it. Anybody have exper
Electronics Forum | Fri Nov 11 04:06:46 EST 2005 | arnold
we are manufacturer of molded type transformer. we have a trim and form process and its damage the pins of our units. the TIN insulation was being damage so we decide to immediately solder (wave soldering) the units to avoid oxidation. my question is
Electronics Forum | Fri Nov 11 04:35:06 EST 2005 | Rob
Hi Arnold, Some wave solder machines have a preheat function, that raises the board temperature before soldering. Some transformers use single use thermal fuses/TCO's inside, that trip at a set value (in a range approx. 70 degrees C to 180 degrees
Electronics Forum | Sat Nov 12 07:25:26 EST 2005 | GS
In other words it should mean that Lead Free Soldering Process (this SACs era, and not for istance classic Lead Free Sn/In used since many years ago) is still a "Baby Technology" and so we need experience and feedback from the field before to issue
Electronics Forum | Fri Nov 11 15:54:48 EST 2005 | Cmiller
We have an SPM with manual vision. Its the best manual printer we have ever had. I believe you can get one used for around 10K. If you buy a realy old one, make sure it has the air table lock!!! I think they only made a few that didnt.
Electronics Forum | Tue Nov 15 09:50:40 EST 2005 | chunks
Good ol'Wenesco. That's one of my old products they have in their advertising. The tricky part about dip process is in the fluxing. Spray fluxing a populated board from the bottom looking up can be a challenge. You'll notice the areas you missed
Electronics Forum | Mon Nov 14 08:19:19 EST 2005 | cguerrero
Has anyone had issues with their glue stations. After our software upgrades it seems to not be working properly. We have had it slam into the pot, not go into the pot, slam the arm, etc.. Default glue dots used to work now I have to set all their bi
Electronics Forum | Wed Nov 16 05:24:55 EST 2005 | Rob
Hi Carsten, 20,000 Euros is a LOT of money for an MS128. Make sure you get a lot of feeders, warranty and spare parts thrown in, and that there are no hidden extra costs. We had 2 MS128s & 6 HS180s & they did a reasonable job & were easy to work o
Electronics Forum | Mon Nov 14 12:11:20 EST 2005 | binhanhaokiet
We just bought a used TP9-2U, I could not do a W-wagon camera calibrate. It keep saying "Calibrate failed, can't located all point", I do not know what should I do next. I did refocus the camera but it still does not help. Please help
Electronics Forum | Mon Nov 14 12:16:54 EST 2005 | Ajay
Hi, I have a lead free solder joint 75micron wide & 3mm in length with copper on either side of solder. Is there any method/relationship between Cu dissolution & Cu weight% so that one can determine how much copper can be present in the solder afte