Electronics Forum | Tue Dec 16 16:58:56 EST 2008 | diveng
I have a TRS182 Oven from BTU with a 3615 controller. After 20 years the battery in the DS1216 finally died. I replaced the DS1216 but now I am getting an error that says the non-volatile memory needs to be initialized. Does anyone know how to do thi
Electronics Forum | Thu Apr 23 21:07:09 EDT 2009 | luismolinero
Emilio: Several factors you need to take into account and your process parameters will depend on: Solder Alloy, Is there any Fine Pitch?; BGA?; Smaller chip size?. Tipically you should go for controls in: Solder Temperature and viscosity; blade and s
Electronics Forum | Tue Jun 09 12:35:18 EDT 2009 | jdumont
We have used an Asymtek C-740 for about three years now and its never had an issue even once. We spray Humiseal acrylic so I cant help you too much with the silicone but the machine itself is great. Opt in for the little process control extras lik
Electronics Forum | Fri Aug 07 15:56:56 EDT 2009 | davef
Well, since you've gotten no takers, we'll launch in to this with careful analysis and introspection, fully aware that we're likely to get 'blasted' for any number of reasons. The most critical parameters to monitor for proper wave solder machine pr
Electronics Forum | Mon Sep 21 11:29:52 EDT 2009 | edmneb
The part we are looking for is the touchscreen controller manufactured by Microtouch. There is no specific part number called out in the UIC drawing book, but the part that we found on the PCB of the Microtouch unit was 7209401. We did swap the con
Electronics Forum | Fri Oct 02 11:33:49 EDT 2009 | floydf
I've got a Universal axial machine with an 8221 controller on it. It stopped communicating to the monitor. Also, when I start it up the run light comes on for a second and then goes off. Does anyone have any ideas on where I can find information for
Electronics Forum | Wed Jan 13 22:59:53 EST 2010 | goolash
The Central Controller software on our Quad IVc machine is refusing to allow me to add local fiducials. Essentially, I follow the manual's directions, and when I press 'N' for New, it asks me to enter the placement number. No matter what number I e
Electronics Forum | Mon Mar 22 10:33:11 EDT 2010 | bobpan
I dont recall autoprogram having a password. If its central controller you need to get into....try QUAD (in caps). There is a way to delete the password file but its hidden in the root directory (for central controller). The file is called QSPASSWD.S
Electronics Forum | Thu May 13 17:08:38 EDT 2010 | gregcr
prompt appears hit enter, another prompt should appear. Now set Diagnostic/Run switch to run, start vision system software load. The vision software can not load if the system is in running arbitrary code and hung in a loop so halting the controller
Electronics Forum | Tue May 10 07:57:49 EDT 2011 | mosborne1
Are you uploading the mod codes to your central controller when you change them? If not when you run your produciton the central controller will download the mod codes that are stored in the CC. You might also have an encoder problem. When the machin