Electronics Forum | Fri Sep 26 14:06:01 EDT 2003 | lysik
You are right. Since that time they have come down to $1500 to register software. Not so bad. The key is to charge a fee that would not prohibit a sale of a used system.
Electronics Forum | Fri Sep 26 17:47:41 EDT 2003 | slthomas
Bwahahahaha! At least shipping our design standards would be a cheap operation. It'd fit on the back of a postage stamp. Yep, down to RH we go this eve. I'll hoist one for the board. One for Dave. One for the board.... Best to you all.
Electronics Forum | Thu Nov 06 09:05:14 EST 2003 | russ
Add some orange juice! Seriously, with a high PH adding almost any form of acidic soluble material will bring it down Russ
Electronics Forum | Wed Nov 12 07:19:38 EST 2003 | ghenning
Manually move the beam away from the limits with the power down. Be sure the beam is parallel (marks to help with this are on the Y-axis lead screw covers near the machine front) and then power up again. Good luck.
Electronics Forum | Tue Nov 11 21:21:49 EST 2003 | Dean
What do you guys do with your old, used VOC free flux? Can you just send it down the drain? Or is it considered hazardous, and should be disposed of accordingly? Thanks for your replies.
Electronics Forum | Mon Nov 15 21:13:17 EST 2004 | chenandy
My company have CRX-2000 machine,right now have some problem,director controller box up/down & forward/back always automatic move
Electronics Forum | Thu Jan 29 18:01:20 EST 2004 | davef
Rethinking to Ramp / Soak: Yano, staying with ramp might not be all that bad after all, just decrease the ramp / slow-down the conveyor.
Electronics Forum | Fri Feb 27 07:48:34 EST 2004 | mk
Sorry I am late with the solution but I have been out on the road. Absolutely the reason solid solder deposit was invented. Hands down the best and most affordable, dependable solution to your challenge. http://www.sipad.com mkehoe@sipad.net
Electronics Forum | Fri Feb 27 16:02:20 EST 2004 | Zaxx
Hi Paul, One way but it slows down the process, is to get fixturing pallets made. You can usually get a universal fixture made for anywhere from $185-225USD. Hopefully this can help. Sincerely, Zack Schmad
Electronics Forum | Tue Mar 09 22:47:26 EST 2004 | pdeuel
Contact sensors out of adjustment. If you push up on spindle the led should change state. same if spindle is pulled down. I have also had problems with PTIF error during zeroing Soft stop. last messages recieved were reported as z axis time out durin