Electronics Forum | Mon Sep 24 17:38:18 EDT 2001 | mparker
First question - do you have a rework station? If so, are you experiencing the same type of failures there? I have successfully used no-clean on uBGA's in the past. 6 mil solder bumps, 10 mil spacing. 88 sites. Are you reusing previously soldered uB
Electronics Forum | Mon Apr 01 19:57:07 EST 2002 | davef
Selective soldering machines are a good way to "finish automation", if the design of the PCB is conducive to the application with just a few components to solder. Your points are good. A decision matrix for selecting a machine might also include:
Electronics Forum | Fri May 17 15:50:17 EDT 2002 | davef
Now that�s a switch. Most are moving or properly have moved in the polar opposite direction. Dano, has someone been drilling your teeth lately? We use water washable flux to: * Remove solder balls. [Or put another way, we don�t have to screw-down
Electronics Forum | Wed Sep 10 11:57:14 EDT 2003 | Mike Konrad
First, you must determine a few things: 1. What specific de-fluxing chemical are you going to use? Basic required determinations include the chemical�s pH, is it a VOC (if so, what is its VOC content), what concentration is the chemical used in (1
Electronics Forum | Fri Nov 07 12:48:31 EST 2003 | rholland
I have seen in the last couple of months more boards with a white hazing under the solder mask. I ran a few tests on a board to determine the cause of the white hazing underneath the solder mask. First I confirmed, or at least I think I confirmed, t
Electronics Forum | Thu Jan 08 16:16:09 EST 2004 | Dean
My first concern would be the choice of solder paste you have. There are better chemistries out there that far exceed the capabilities of the 609 2. Yes, the part will partially float on the solder (assuming plastic qfp). Cross sectioning would sho
Electronics Forum | Sat Jun 12 00:34:00 EDT 2004 | kanwal324
Hi ! The main problem being faced currently is formation of solder balls - to be precise, these are micro solder beads generally found attached with bodies of SOTs, Chip Caps, Chip Resistors, between pins of SOICs (50 mil) - lying on PCB surface,
Electronics Forum | Thu Oct 14 12:12:21 EDT 2004 | Shean Dalton
Hello JB, Based on the double sided assemblies, the misprint cleaning process can demand the cleaning system to remove both raw solder paste from the misprinted side of the board, and, reflowed flux residues from the assembled side. Recognizing and
Electronics Forum | Tue Feb 13 15:56:16 EST 2007 | darby
Campos, This is a direct reply I recieved from Indium, (thanks to Rich Brooks), in late 2004 regarding SMQ230. I have followed these guidelines with good results using ENIG finish. Same also applies to Indium 5.1 apply to both alloys (SAC 387 and 305
Electronics Forum | Mon May 12 17:59:55 EDT 2008 | rgduval
We're currently experiencing a spate of solder not wetting to pads of PCBs, and it's becoming more aggravating on a daily basis. At this point, we're running out of ideas. I've searched the Fine Archives for information, and, so far, haven't found
