Electronics Forum | Tue Jun 19 13:13:07 EDT 2012 | rodrigo
Hi all, Is there a generic heating element I can buy for this oven? The Heller part number is 682991. They want about $300 for the pair which doesn't sound too bad for me but .... I'm not the one writting the check :-). Thanks
Electronics Forum | Fri Jun 29 07:47:16 EDT 2012 | mosborne1
Dave Thanks for the input. The thermocouple read 244 on the pad of the socket. We actually found after extensive investigation that it is the coplanarity of the leads. We were shipped a bad batch of sockets form the manufacture. Go figure!!1
Electronics Forum | Tue Jul 10 03:31:14 EDT 2012 | buckcho
Hello, the best way is to set the oven to cooldown. Opening the oven is not very good idea, but is not a big issue I think, only bad air in the production. Try if you can to make production from glue to Pb free if it is possible.
Electronics Forum | Mon Jul 16 07:33:34 EDT 2012 | amitsindwani
Why to use 5% color spot in HIC if level 2a-5a are considered bad when 10% is NOT blue ? 10% will be NOT blue(or pink) only after 5% is pink. Then why to keep 5% in HIC ?
Electronics Forum | Tue Sep 04 12:05:52 EDT 2012 | duchoang
cobhambill is right but depend on how bad the defect, and how good your printer is, you can reprint it one more time. I did sometimes with my equipment with no problem. It's hard to clean NO-CLEAN solder-paste properly, specially with panelized PCB w
Electronics Forum | Fri Oct 05 03:22:41 EDT 2012 | ekki511
HI Jeff may be there was a bad , did you mean 6500,- or 650,- USD regards Ekkehart
Electronics Forum | Thu Feb 21 08:52:24 EST 2013 | emeto
Currently having Elecrtovert and BTU - no problems with both. Before use to have Vitronics aand Heller - and no problems with the rails. However I had other problems with Heller which makes me think that they are going deeper with the bad quality par
Electronics Forum | Mon Mar 04 07:33:25 EST 2013 | cyber_wolf
*There are instructions that come with the amp on how to set it. *I have never had to replace a FRQ or FQ motor, or any motor on a Fuji for that matter.I highly doubt the motor is bad. *The meshing check sensor verifies that the clutch is engaging c
Electronics Forum | Fri Mar 15 18:26:51 EDT 2013 | hegemon
We avoid kapton in this situation due to the thickness. 1 mil additional thickness can equal up to a 20% increase in paste volume at adjacent pads if you are using a 5 mil stencil. But then again, that is not always bad. But must be taken into consid
Electronics Forum | Mon Mar 25 14:59:55 EDT 2013 | jimmyboz
Yes, he is correct, it is probably a sensor. That does NOT mean a sensor is bad, just that it has not been activated during a time limit or servo count. Watch what the last 2 or 3 things it does before the error.
