Electronics Forum | Fri May 06 10:18:43 EDT 2011 | bobpan
Hello Doug, There is no tuning up of the cyber-unit. From the symptoms you describe......sounds like the white cable that plugs into the cyber is intermittent. Maybe you can find one somewhere and try that. The cyber unit is a closed assy. and was ma
Electronics Forum | Thu May 12 10:02:21 EDT 2011 | scotceltic
Our company has it's yearly inventory coming up. (Joy). I was wondering if anyone has come across a component counter that can handle radial components in AMMO pack. I have seen plenty out there that can handle counting of radial components in Reel
Electronics Forum | Wed Jun 08 08:33:56 EDT 2011 | fredc
Unless you have a feeder with unusual vibration that is generated during the advance it seems that the issue is packaging. Try another feeder that has been tuned up and properly lubed. Most high speed turret machines move the feeders back and forth a
Electronics Forum | Thu Jun 09 10:01:06 EDT 2011 | pcbrookie
Thanks for the input! In looking at the image again, along w/ some of the others we were supplied with it does look like it could just be too much solder. As mentioned, that does look like a lot of solder bridging up there. It will likely be a wh
Electronics Forum | Tue Jun 28 14:55:11 EDT 2011 | remullis
Typically TH equipment has 2240 Unused steps if no pattern is loaded when running a pattern it takes up whatever amount of steps deducting from the 2240. With no patterns loaded in my axial machine I only have 246 steps. Would this be a time to relo
Electronics Forum | Wed Jun 29 10:26:58 EDT 2011 | remullis
I've been using 29x29 framed screens for years. I have a company that has come up with a adapter that would mount in my screen printer and utilize just the foils of screens. It basically fits and is clamped into the adapter. I am struggling with floo
Electronics Forum | Thu Jul 21 10:48:02 EDT 2011 | emeto
We use QTS and Vectour guard. I would prefer Vectourguard - it is very siple to set it up. However, you have to check the tension of the stencil everyday. I wouldn't trust them as 29 inch hard frame. It is always a metter of quantities. If you deal w
Electronics Forum | Fri Jul 29 18:00:31 EDT 2011 | daveatdt
There should be a "Tracking" button at the bottom of the screen that you can just tab over to, then press the green start button. I have not worked with the 730, but it is that way on our 740, 750, and 760 machines. Alternatively, you can move the cu
Electronics Forum | Tue Jul 19 15:04:10 EDT 2011 | ccouture
Seika make a solder paste recycling unit that will melt solder paste and separate the solder from the flux. You end-up with liquid flux in a jar and a block of solid solder, which you could re-use in a solder wave if the type is the same.
Electronics Forum | Wed Aug 03 11:07:29 EDT 2011 | cyber_wolf
IP3 camera calibration requires someone that knows what's going on to do it. Unless you have been trained on this specifically I would recommend that you don't attempt it by yourself. I believe the button jig is used for squaring the camera up. You
