Electronics Forum | Mon Apr 06 10:16:43 EDT 2009 | samitokgoz
Hello, Does anybody have Seho 8040 (wave soldering machine) user and maintenance manual? I have a document for 8000 series but it would be better if I had one specifically for 8040 model. Please send to sami.tokgoz@selex-comms.com.tr if you have it.
Electronics Forum | Mon Apr 06 17:31:25 EDT 2009 | miguerre
Hi, We are currently in the process of selecting equipment and I was wondering if you had any comments on your experience with Manncorp. We are looking for Stencil Printers, Reflow Oven, Cleaner (SMT Aqueous Sys), and maybe others. Is this a good b
Electronics Forum | Tue Apr 07 12:41:19 EDT 2009 | rodrigo
Hi All, What causes the z tower to fall/slide down in this machine? There is a break at the bottom of the motor but the book says that it is for when the machine is off. It could happen at any moment. It sucks when it is in the middle of printing a
Electronics Forum | Wed Apr 08 10:23:38 EDT 2009 | cyber_wolf
I am assuming this machine has a tactile sensor that mounts to the printing table. If the air connection or any of the wire connectors get under the rear rail it will cause the Z to fall. Also any bare wires on the tactile sensor that touch the prin
Electronics Forum | Wed Apr 08 04:29:14 EDT 2009 | kircchoffs
Hi Rodrigo, is your problem occurs only at 2nd device table? how about if you transfer the feeders to the 1st device table? if it happens at both device pls your part data if there's a value at pick-up. you can also check the proper data of the de
Electronics Forum | Thu Apr 09 10:28:09 EDT 2009 | winndom
We are looking to buy an AOI and 2 SPI machines. 3 AOI vendors we had one hour demo with at are MVP, VISCOM and CyberOptics. Before making our decision, we would like your feedback and experiences with those vendors. We would like info regarding how
Electronics Forum | Thu Apr 09 12:27:12 EDT 2009 | devgru
Hi Dominic, By any chance did you look at yestech? I have a couple of their systems and have one dedicated for SPI. A while back, I did look at the CyberOptics SPI system, and while a very good system, I couldn't get the ROI into a range that was goo
Electronics Forum | Thu Apr 09 13:38:41 EDT 2009 | thenrz
I'm working with a GSM machine and have a question - How do I go about using a local fid to act as a bad mark? Is that even the way to go about it? I have a stack of board here with one or more badmarks and it is a waste of time to keep modifying
Electronics Forum | Fri Apr 10 13:25:08 EDT 2009 | jefflkupkt
Layer 2 is the ground plane layer of a 4 layer board. After installing a 2.5 mm DC power jack and 0.1 center SIP header by hand, the ground pin disconnects and causes an open. My board supplier said they passed Electrical Test. Prepreg was within
Electronics Forum | Tue Apr 14 15:01:00 EDT 2009 | mki
Thank you RLM, bobpan, Laser (CyberOptics) was dirty! Now is all OK. You are talking about Quad-Align. I have a lot of QUAD manuals and I still do not understand the diference among QuadAlign, CyberOptics LA and L3 LA! Please, if you can give me s