Electronics Forum | Fri Sep 08 16:12:38 EDT 2006 | Buzz
NO! We need to try to initiate the description of the criteria for requirements by developing a framework for the application architecture consistent with the planning corridor specified in our strategic initiative. Once bilateral goals are establi
Electronics Forum | Fri Sep 08 09:16:37 EDT 2006 | james
We are incurring problems with Film Chip Capacitors with reflow issues. Some of the parts are misaligning or not soldering on one end (almost tombstoning) . We left the parts in the dry cabinet till they were used. We tried both reflow ovens (hell
Electronics Forum | Thu Sep 14 19:19:38 EDT 2006 | SWAG
I would try to panelize as big as you can for sure as you'll spend more time handling single boards than running anything. Additionally, this size is very close to smallest capabilities on GSM depending on your configuration. Fids on all boards in
Electronics Forum | Wed Sep 20 06:01:20 EDT 2006 | bobpan
Sounds to me like your nozzle isnt seating on the z-rod bellows. Pick a nozzle up by do a 'runstep nozzle'.....then do a function 30 ( i hope thats the function because its been YEARS since i worked on a c'series). It should give you a nozzle height
Electronics Forum | Wed Sep 20 15:25:15 EDT 2006 | lheiss
Hey All, Thanks for all of your help to date. While running the nozzle height test I noticed that the Z-rod is bent. Probably happened after setting the "X closed loop soft home" back to 50 from 384 which was probably why the nozzle slammed into t
Electronics Forum | Mon Sep 25 12:50:42 EDT 2006 | chris g
Daxman, The diagnostic results didn't look very pretty. Especially on the vision x standard deviation. Any time there is an asterisk, that is a bad thing. The failure number for all axis, excetp theta, is .0002. Could need more air flow to the x
Electronics Forum | Tue Sep 26 10:22:51 EDT 2006 | SWAG
Histogram: Place standard tooling block in centernest. Jog camera over block. Jog z-axis to soft limit. Place a white card under camera. User mode to test. Turn board lamp on. From test menu, select histogram. With board lamp on and white under camer
Electronics Forum | Tue Oct 17 18:15:39 EDT 2006 | daxman
Hey all, I just though I give you all a quick update. I managed to get the printer working. The problems were a combination of everything that was discussed here. When I adjusted the GS4 pot for the histogram, I turned the wrong one at first. This t
Electronics Forum | Mon Oct 02 16:38:20 EDT 2006 | lheiss
Brad, Thanks for the info. Now that I have my align data set correctly I'm having this problem. I've greased and realigned until I'm blue in the face. If I do a nozzle change then a function 30, press the nozzle on with my finger and do a functio
Electronics Forum | Tue Oct 10 11:06:04 EDT 2006 | lheiss
Hi All, I wasn't sure how this would turn out until I ran some production. As I suspected, after every nozzle change the machine dumps the first 3 pickups, checks the nozzle height again (function 30?) and then begins placing with correction with n
