Electronics Forum | Mon Jan 10 18:22:43 EST 2011 | eadthem
What we use for boards the engineers made to big is aluminum flat bar 1/8 to 1/16 thick about 1 inch wide. we fold it in 1/2 so it fits snuggly on the pcb and just press it on the ends before reflow. id assume the same thing would work on wave but
Electronics Forum | Wed Dec 08 19:16:20 EST 2010 | jgalarza
Can anyone tell me if there is a formula for finding the after reflow height of solder with no part attached? I have to print some pads that do not have any parts but there can not be more than 1.5mil of solder on the pad after reflow. I am going to
Electronics Forum | Thu Dec 09 07:21:10 EST 2010 | scottp
You won't have 2 mil height because the solder doesn't remain brick shaped. It's a dome. In the past I tried doing some calculations using the formula for the volume of a spherical section and also tried using a simulation program that accounts for
Electronics Forum | Tue Dec 14 02:29:55 EST 2010 | sachu_70
YAMAHA has been OEM to Philips for CSM range machines. Hence it is certainly recommended to have your machine one-time completely overhauled by YAMAHA before you decide to engage local 3rd party agencies for maintenance or maintain in-house. The cost
Electronics Forum | Fri Dec 10 01:02:36 EST 2010 | sparrow
Hello, our products are made on single-sided boards and we often have problems with receiving too warped PCBs from our suppliers. Can anybody suggest a good laminate or the most important properties of the material so we could specify it when we orde
Electronics Forum | Fri Dec 10 09:49:08 EST 2010 | reic1
We recently purchased at auction a KANETIC KTT4402D board turner for our SMT line. Little did I realize that there is no way to contact the company. does anyone have one of these units? I need manuals. I stumbled across a password that gets me to
Electronics Forum | Sat Dec 11 23:15:01 EST 2010 | smt_dude
My APS GF12 seems to have lost it's settings randomly last night, and it won't let me run any profiles unless it's autotuned. I've figured out the security password and can get into the tuning menu, but not sure what to do from here. Anyone know wh
Electronics Forum | Mon Dec 13 17:40:40 EST 2010 | smt_dude
APS hasn't replied yet, but past experience tells me they won't do anything without a significant fee. In the meanwhile, I got some info/assistance from someone else on this, and hoping it gets this working again. I'll find out later when I'm at th
Electronics Forum | Fri Jan 07 08:18:45 EST 2011 | mosborne1
We are a raw board manufacturer located in Charlotte, NC. we have been here since 1975. We can support all levels of volume. We can even ship double sided boards same day as we get the order. Check us out online - www.americancircuits.com
Electronics Forum | Wed Dec 15 13:03:43 EST 2010 | ssager
We have been struggling with first article inspections and have built entire lots incorrectly many times. This seems to affect us on both SMT and Through hole assemblies. We have an AOI, but it is not in-line. Does anyone have any advice for putting