Electronics Forum | Fri Feb 05 02:40:40 EST 2021 | victorzubashev
For components with the large pads, you can also use secondary soldering dispensing. Some printers like DEK have an option to mount a syringe with an auger valve to do dispensing after the printing step process. Obviously will not work if you have to
Electronics Forum | Thu Mar 04 15:11:45 EST 2021 | mendez
Thats good to hear. I have (1) extra boards for the LCD and the Motion drivers in case something gets damaged later because as you mentioned; parts are very difficult to find (or super expensive) I did soldered the IC chip on the LCD unit and get RE
Electronics Forum | Tue Mar 09 20:58:48 EST 2021 | emeto
This have been solved by storing the boards right in all places I have worked. You open a pack, label and use. If you collect dust in such a small time window, you should totally start paying for cleaning service of the building. Electronics we build
Electronics Forum | Mon Mar 01 22:51:05 EST 2021 | rob1
We have a DEK 265 Horizon and it exhibits a problem with conveyor belts. When I power up the DEK and try to paste boards, it fails to initialize the conveyor. I have to go into Maintenance and select cycle boards on rails. This too fails, but when I
Electronics Forum | Tue Mar 02 17:41:04 EST 2021 | astarotf
The heads in the middle of production stop and this error appears. We already checked the readers, linear encoders and changed the UIMC cards and found no errors, apparently all these revised parts are working. Can anyone help us where else can we c
Electronics Forum | Thu Mar 11 16:59:00 EST 2021 | toledog
Hi Tom, Thank you for offering the UP500 drive image. As stated above, direct email is not working for me. I created a temporary google document with my contact information. https://drive.google.com/file/d/162fF57RAkt1TwFUY5sDhpH9RrcSU0ND6/view?usp
Electronics Forum | Fri Mar 26 08:55:45 EDT 2021 | manaik
Hello, We have purchased used Koh Young AOI, the setup does not let us through when you start MCS on start, it says RJ45 connector is out, which is not. delta tau clipper conntroller. The swithc on INIT must be ON or OFF? Do the lights work even wi
Electronics Forum | Fri Apr 16 15:12:12 EDT 2021 | jsmith01
Does anyone know where the power to the lambda, chip sensors comes from on a Electrovert EPK plus? I have an intermediate issue with these sensors loosing power and the wave just keeps going higher and flows over the pot. I have replaced the senors
Electronics Forum | Fri Jul 30 05:16:04 EDT 2021 | compit
Ok i did this: when optimizing PCBs, you can add "fixed PCB" - the machine treats this PCB as the one for which the feeders have reserved space. I enter places in such a PCB that are to be omitted during the allocation. It works very well - selected
Electronics Forum | Tue May 11 16:25:06 EDT 2021 | dontfeedphils
Anybody have a tool for expanding ranges in Excel? (Example, for converting reference designators listed in a single cell as R1-R100 to R1 R2 R3 R4... etc). I used to use a tool named refinate, but it's no longer supported by the developers and it