Electronics Forum | Wed Dec 22 05:42:19 EST 1999 | Wolfgang Busko
Hi John, I�ve seen problems some sites have or had with bridging problems in the wavesolder process with 1206 and 0805. Adjusting the system and focussing on the flux parameters sometimes improved things. With some older systems it was hard to get s
Electronics Forum | Fri Dec 10 12:40:44 EST 1999 | Brian W.
It sounds like the process is very labor intensive, and all the verification is done after the parts are soldered. Assuming you are hand placing the components: 1 - Contact Systems semi-automatic placement machine. It show polarity when placing, so
Electronics Forum | Mon Dec 06 04:40:39 EST 1999 | cklau
Halo; In your last message you did not mentioned why your customer need to use IPA to clean PCB's as their requirement and what subtances they want to get rid of (is it flux stain PCB's or component?).If so recommend your value customer of flux 910
Electronics Forum | Fri Dec 03 03:58:12 EST 1999 | Wolfgang Busko
Hi Charly, For batch ovens there is no discussion. For inline loading interval depends on the oven you use, the amount of heat the PCB takes out of the zone and the capability of the oven to get it back in. The approximate time for the PCB to stay i
Electronics Forum | Sat Dec 04 09:23:20 EST 1999 | Christopher Lampron
Kantesh, Does this particular part have a heat sink across the bottom side of the component and does your pad size and stencil aperture match the component? I have just had a very similar problem with a DPAK. What we found was that the recomended pad
Electronics Forum | Fri Nov 26 10:36:37 EST 1999 | Wolfgang Busko
Hi Edgar, we had a similar thread in summer this year on this forum. Not in particular focusing on every detail of this topic but more of a philosphical view of some aspects of your intentions. Positive: It�always good doing new things. Combination o
Electronics Forum | Thu Nov 18 19:45:26 EST 1999 | Deon Nungaray
Deon Response: Hello Will, Yes, you can reflow a double sided board using 63/37 solder paste on both sides. There are some limitations as far as the mass of the components to reflow the second time. If you have doubts or are concerned that a compone
Electronics Forum | Mon Nov 15 10:43:23 EST 1999 | Brian W.
I think the issue may be more than just the oven. I worked at a facility in Florida, where lightning strikes were common. We installed backup generators for the facility. Among the issues and costs we analyzed were: frequency of outages, boards i
Electronics Forum | Tue Nov 16 14:38:46 EST 1999 | Scott S. Snider
So far I'm into the investigation stage of the AOI project. The system I'm most interested in is the Intelligent Reasoning Systems, Inc. I'm after fast programming with minimal false calls. I'm not interested in X-ray. I saw the system at NEPCON
Electronics Forum | Tue Nov 16 14:42:25 EST 1999 | Scott S. Snider
So far I'm into the investigation stage of the AOI project. The system I'm most interested in is the Intelligent Reasoning Systems, Inc. I'm after fast programming with minimal false calls. I'm not interested in X-ray. I saw the system at NEPCON
