Electronics Forum | Sat Jan 20 23:48:55 EST 2007 | bvdb
Hi Al, Thanks for the suggestion. Yes, I should have said that the cable has been checked and another cable tested with the same results. In addition to the three wires that carry the transmit data, the receive data and the data signal ground, the
Electronics Forum | Sun Apr 15 20:58:17 EDT 2007 | darby
PCB > Origin > O* > Skip = No Data In > PCB > Mount > M* > Skip = No Data In > System > Parameter > Position > Waiting Pnt Check that the waiting point is not set at such a co-ordinate that the PCB sensor is seeing the gantry. The pcb sensor also h
Electronics Forum | Fri Jun 22 00:05:15 EDT 2007 | sarason
Is anyone else using XON/XOFF handshaking, or is it best to >use CTS/RTS hardware handshaking? If you are using >XON/XOFF, what parity settings are you using? (Not unheard >of for the XON/XOFF chars to not obey the parity settings >for data chars.)
Electronics Forum | Mon Jul 15 09:42:49 EDT 2019 | mleclair
I purchased some RS232 breakout board connectors so I'm making the cables now based on the pinout document page 4 (DB9 to DB25) but i'm still getting the message below: "unable to transmit to machine 61700025 Unable to log on to the Machine Communic
Electronics Forum | Wed May 19 20:24:09 EDT 2021 | kumarb
Thank you Michal. Very much appreciated. We are thinking along the same lines. However, we are being very afraid to even cut the official wire ties that are securing the head 1 and head 2 wiring. We have a new VAC2 solenoid in transit that will arr
Electronics Forum | Fri Jul 09 17:52:43 EDT 2021 | glasscake
Hello, I have a Topaz-X that is losing its R origin as it runs. The issue can be seen in the following test: Set the machine to ignore vacuum/ignore alignment and have no feeders in the machine also set the nozzles all to fixed. I run a servo orig
Electronics Forum | Tue Jun 05 06:45:46 EDT 2001 | jackofalltrades
I am not in your area to provide physical assistance, but I'm full of advice. Keep in mind you get what you pay for. One thing you can do is what you have done here, watch this forum and others like it. You will see where the short comings are. Obvio
Electronics Forum | Mon Aug 23 21:50:13 EDT 1999 | Mike Konrad
I use the Olympus C-2000 Digital Camera. It has 1600 x 1200 resolution with 2.1 mega-pixels. Nothing gets by this camera. It should pick up all of the detail you need. This model is a bit expensive though (about $ 1,000.00). It features a nifty
Electronics Forum | Tue Oct 23 08:38:52 EDT 2001 | MikeF
Dave, Thanks for the suggestion on the used equipment brokers. I had done a search of the Marketplace for this machine, but should have thought to contact one of the brokers. Vitronics can sell me a manal, but has noted the manual does not have any
Electronics Forum | Tue Mar 05 07:56:32 EST 2002 | jax
I am not familiar with networking the machines in question. What type of OS do the machines run on? How does the Panacim software network the equipment? If you only want to access all the machines offline for file transport and do not plan on using t
