Electronics Forum | Mon Oct 24 13:42:28 EDT 2022 | cyber_wolf
If you want that kind of CPH you will require a new machine or a multiple machine line. The published rated speeds "under optimal conditions" are BS. Easily take 30% + off those numbers to get closer to real world.
Electronics Forum | Fri Oct 28 19:11:20 EDT 2022 | dwl
Hire a fat guy to sit on them. My rates are very reasonable if you'd like a quote...
Electronics Forum | Wed Nov 09 17:22:06 EST 2022 | emeto
1. For laser machines, there should be setting for Z - at what level you should cut measure the part in Z axis. 2. Check all calibrations are in place and passing 3. Check resistor package setup in the software - all dimensions
Electronics Forum | Tue Jan 03 13:34:08 EST 2023 | dontfeedphils
Just to add some more caveats, the rate at which the paste leaves the tube will also be dependent on the (somewhat) fluctuating variables of temp and humidity. This is why a height measurement of the paste roll on the screen works better.
Electronics Forum | Fri Mar 24 15:22:23 EDT 2023 | smtusa
Wow, in how many years? Is it possible you got a lemon or an early model? How do Jukis compare to Yamaha/Assembleon? The older models seem to be rated slower.
Electronics Forum | Mon Mar 27 02:13:45 EDT 2023 | erikfriesen
What is the nameplate rating on that machine? Do you have any special zone heating to keep it lower amps?
Electronics Forum | Fri Sep 22 17:27:51 EDT 2023 | calebcsmt
How does one determine a cold joint seam vs simple cooling lines from solder cooling at different rates or part of the joint not reaching liquidous (very large pads)
Electronics Forum | Thu Feb 08 16:26:39 EST 2024 | proceng1
I know that we maintain lower PPM count from our N2 Generators when we can lower the flow rate. I'm not sure if that would help you or not.
Electronics Forum | Thu Jan 13 09:00:42 EST 2005 | fasst1
Grant, Again, just my .02 worth. I would have to agree with Greg as well. Two Flex machines from the same vendor will give you much better line balancing, and I think better overall capability than adding a different type of 'animal' chip shooter
Electronics Forum | Fri Feb 26 19:27:04 EST 2010 | dcell_1t
you can find a very helpful guide here... http://www.oee.com/pdf/oee-pocket-guide.pdf We basically have a database where operator input the boards produced per hour and if he can't reach the "standard" he can input a downtime issue and assign to a