Electronics Forum | Wed Jun 19 07:53:52 EDT 2013 | ehess
Does anyone have any input on ESD Epoxy flooring, positive or negative?
Electronics Forum | Sat Jul 06 19:49:41 EDT 2013 | sarason
My software can easily open a PCB CSV file so this is probably the easiest way for you to generate a file. The setups are remembered via a write to the registry, so you can go with a standard set of values to arrive at a very usable file without havi
Electronics Forum | Fri Jul 19 16:27:38 EDT 2013 | microaide
I think I have the vision problems figured out. There were two problems. 1) The Alignment type was set to "Small" for my TQFP48 part. It should have been set to "Complete". This is a clear case of poor documentation. The AutoProgram manual lists the
Electronics Forum | Fri Jul 19 08:57:57 EDT 2013 | emeto
Europlacer have model that can do up to 1500mm length
Electronics Forum | Wed Jan 08 08:30:14 EST 2014 | sgenovese
Hi I have the same problem. Did you found the cuase of the problem? Best regards Silvio
Electronics Forum | Thu Aug 01 13:48:13 EDT 2013 | cyber_wolf
They have been claimed. Thanks
Electronics Forum | Tue Sep 10 13:02:51 EDT 2013 | jimmyboz
Do You still have the problem?
Electronics Forum | Wed Sep 25 12:42:30 EDT 2013 | Chris
You have to make sure the tape is covering the holes, this is where the sensor reads the tape.
Electronics Forum | Mon Oct 14 14:35:51 EDT 2013 | garym4569
Thanks for the replies. I have just ordered the IPC Stencil Design Guidelines manual.
Electronics Forum | Mon Nov 11 15:05:07 EST 2013 | cbeneat
Have you tried soltec? This is the default on our Delta wave.