Electronics Forum | Mon Oct 12 00:55:02 EDT 2015 | edriansyah
Hi nhel, if you're talking about software back up. it's quite easy. normally when you're system are set by the SAKI tech, they will create a back up of the saki software. this is their standart procedure. mine were located on the My document. he put
Electronics Forum | Thu Oct 22 05:36:58 EDT 2015 | myleb
Hi Nhel, It's quite strange problem here... 1. The voltage check: please supply power voltage. Inside machine (BF) there is a transformer, please make sure the voltage setup is correct. 2. In Ringload information, please see the 12V and 24V, is it
Electronics Forum | Thu Dec 31 19:25:11 EST 2015 | ttheis
Resolved. Thanks to some information provided by the fine folks over at Capital Equipment Exchange I was able to update the system to a EXP-VID-B video card, replacing the EXM-13A and EXM-14 combination. This update eliminates the jumper cable betwe
Electronics Forum | Thu Feb 04 14:08:41 EST 2016 | stevea
Perfect explanation of SPI as a whole. The point I would challenge is considering KY as the premier product for SPI. Yes, this fact could have been backed up 2-3 years ago. Today, KY is just another leading contender for SPI. CyberOptics along wi
Electronics Forum | Fri Mar 25 06:38:47 EDT 2016 | buckcho
Hello, I have used KY and Parmi and I can give you my personal opinion on these two machines. Pluses for Parmi: 1.Extremely fast - for me faster than KY. 2.More simplified than KY; 3.Simpler calibration that KY; Pluses for KY: 1.Superior 3D viewing,
Electronics Forum | Fri Apr 01 17:29:17 EDT 2016 | jlawson
Also note , KY is SPI company and there 3D technology is just SPI tweaked to do 3D AOI, same can be said of Mirtec but bit better than KY. Generally they are slow in capture and this is why in EU and say high volume sites 3D has not penetrated much.
Electronics Forum | Fri Jun 03 10:11:08 EDT 2016 | tnisbet
If you end up buying a depaneling machine/robot, > the guys at Pentagon EMS are very good at making > fixtures. Once they have the specifications of > your machine all you will have to send them is > your panelized drawing of your board. In extre
Electronics Forum | Tue Aug 02 15:02:50 EDT 2016 | davef
ASPIS (Advanced Surface Protection for Improved Reliability PCB Systems) The three year Aspis ‘Research for SMEs’ project has been conducted to address problems found with the nickel gold (ENIG) solderable finishes that are used by the electronics in
Electronics Forum | Fri Jul 22 09:42:24 EDT 2016 | ttheis
Acetone has hazards other than flammability and odor including potential effects on the nervous system, skin, kidneys, GI tract, as well as blood and bone marrow according to the CDC. Perhaps you misunderstood what I was saying regarding alcohol; I
Electronics Forum | Thu Jul 28 15:43:48 EDT 2016 | ddina
Recently started setting up our GSM 4681A system, and one of the machines comes up with the message "WAITING FOR OUTPUT BOARD TRANSFER TO COMPLETE" after the Zeroing process has been started. Machine has all the defaults set, two SMEMA connected univ