Electronics Forum | Wed Mar 20 07:14:10 EDT 2013 | vinitverma
Assembleon AX201 is one of the most accurate odd-form placer. It can place anything, including leaded transformers, press-fit connectors, and of course odd form SMT components. You can even use a gripper nozzle for components without a flat surface t
Electronics Forum | Wed Mar 20 13:06:19 EDT 2013 | kmots15
We've placed some crazy parts with Mydata but always used the mechanical centering jaws as the vision algorithm is lacking for pattern recognition. Could easily do a poker chip (or other circular things) in the X&Y but maybe the text wouldn't be str
Electronics Forum | Wed Mar 13 17:17:42 EDT 2013 | isd_jwendell
I don't know your machine, but on mine the interlock is the large access door. It's done so that you cannot open the cover while running, but it also checks for a closed door at startup due to head homing sequence. Yours may be similar in that it won
Electronics Forum | Wed Mar 13 19:48:31 EDT 2013 | marcelorotofrance
The front door has as security switch, indeed. It works ok. A lever switch for override the door switch is also included from factory. (It don´t look good from the safety point of view but, you know). There is also a presostatic switch on the air reg
Electronics Forum | Mon Mar 18 07:32:18 EDT 2013 | stephendo
It's been a long time but one thing I remember from those machines that about 50% of the time the error codes were a wild goose chase. At this point forget what the error code says. Can you move the head? Have you checked the servo cards? Is there
Electronics Forum | Mon Mar 18 09:19:48 EDT 2013 | marcelorotofrance
I can move the axes XYUV just in short steps through the "MANUAL NC" function. The axis encoders seem to work; the readings of position follow the axis movements. However the actual position of the head has nothing to do with the readings at the disp
Electronics Forum | Thu Mar 14 10:49:44 EDT 2013 | babe7362000
Have others seen a higher rate of machine downtime due to the cover tape on parts not pulling back properly. We have the same problem on the Jukis and Quads. About every 3 minutes the machine stops and the operator has to pull the tape back. And in
Electronics Forum | Thu Mar 14 17:35:39 EDT 2013 | dontfeedphils
Have you looked at the cover tape wheel on these different feeders and made sure that they are turning correctly when the feeder is advanced? There's not too many things that could be wrong, either the wheel isn't turning properly and keeping the co
Electronics Forum | Fri Mar 15 08:20:06 EDT 2013 | torch
we quite often see this on our quads usually only on the 8mm feeders, sometimes the tape roller can become sticky as suggested. usually i just remove the roller and apply a grease to the screw so that it can move freely also make sure that the peel
Electronics Forum | Thu Mar 21 22:27:13 EDT 2013 | padawanlinuxero
Hi ! I have the same problem with some rolls of tape, we did check the feeder magazines in our mydata machines but turns out the problem is with the plastic cover sometime it comes with just too much adhesive that the feeder magazine cant peel the p
