Electronics Forum | Mon Mar 24 00:54:49 EDT 2014 | isd_jwendell
Don't do that! When solder paste dries out, all parts of the flux do not leave. The volatiles leave. Adding new flux messes with the chemistry and %metals and will not perform like new paste. If you can, get your paste in cartridges. It will last lo
Electronics Forum | Mon Mar 24 15:20:15 EDT 2014 | kojotssss
Hello for all People's .I have a question. I have a problems with backup pin placement.When x/y robot tried to set up pins: we got a problem- X=-0.200 and y=-0.880 To my mind ther are a problem with air cylinder and axis.Any solutions?! can you c
Electronics Forum | Fri Mar 28 04:54:45 EDT 2014 | iruindegi1
Hi and thank you for your answer! I created a new thread called SIPLACE SX1 vs FUJI AIMEX II where we want to get people suggestions. The fact is that I´m software developer and my company want to get comunity opinion before to buy a new machine and
Electronics Forum | Thu May 15 03:47:05 EDT 2014 | pcbfox
We are going to buy a new pick & place machine > and we have an offer for a Siplace SX1 and we > want to know your opinion about this machine or > siplace in general. > > thanks Hi yes, it is right that to make it clear first that what kind o
Electronics Forum | Thu Mar 27 07:56:04 EDT 2014 | rrosera
My company is researching the use of re-workable underfill for use on our avionics boards. We are currently testing Hysol UF3810. The Rework machine we use has a vacuum based removal system witch isn't strong enough to overcome the underfill. We have
Electronics Forum | Fri Mar 28 04:49:33 EDT 2014 | iruindegi1
We have to buy a Pick&Place machine. We do small series and prototipes, 2-3 changes/day, so we need a flexible machine, that permits quick changes. We are looking at SIPLACE SX1 and FUJI AIMEX II. Could you give us your opinion? Thanks
Electronics Forum | Sat Mar 29 10:04:03 EDT 2014 | josse
Hello there everyone! Our company just bought an AOI Inspection Machine, and that is the Mirtec MV-2HTL 1.3 megapixel, software rev 4. I am trying to create a program that runs the top side first and then asks to run the bottom side consecutively. I
Electronics Forum | Wed Apr 02 05:31:45 EDT 2014 | jdumont
We have four or five of these guys scattered around our 40,000sqft plant spraying DI water. They have a not so accurate built in humidistat but its good enough and they aren't that expensive for upfront cost. Just lube the packing washers in the gun
Electronics Forum | Mon Mar 31 20:21:54 EDT 2014 | sonavc
Thank you for all help. Finally I got this old machine ran. Now sometimes, I get this error " R FENCE " . I checked the center photoelectric beam at the rear of the machine was good. Sometime I 'm so lucky turn it on and it work. now the problem o
Electronics Forum | Thu Apr 03 12:36:30 EDT 2014 | jimmyboz
Hold the F1 key during power up, it will boot into the I/O screen. Check the 3 photo zones. Check the door switch. In the main screen you can cancel D1 or D2, then you can swap light sensors. Check carefully the wiring, there is a SYNC wire betwee
