Electronics Forum | Mon Oct 19 10:23:24 EDT 2015 | atekcare
Great message that all should pay attention to, I know we do here and have for many, many years knew that good communication and expectation setting was the foundation of satisfied customers. I'd like to hear more about your independent services bus
Electronics Forum | Mon Oct 19 09:59:30 EDT 2015 | cbeneat
I've never had that particular problem with our machine, but I do know that if the CB pop for whatever reason the machine doesn't give an error. So I would check those, if you haven't yet. Also under options you can do an element check, see if that
Electronics Forum | Tue Oct 20 10:14:59 EDT 2015 | aemery
Florin, Not sure if this will be helpful or not, but I have completed a couple of pot height retrofits for these waves and I seemed to remember that one of my clients spilled some solder and shorted out the 24vdc power supply. I am pretty sure this
Electronics Forum | Tue Oct 20 08:38:17 EDT 2015 | nhel_0009
good day, we're encountering trouble in CM602 Mounter and still looking for help..here is the error(cover open A stage front and rear, ext conv open/ConveyorHoleSensorDetect, Outside cover open, Momentary power off. Anyone knows the error ple
Electronics Forum | Tue Oct 20 12:02:47 EDT 2015 | cbeneat
I have never encountered that particular problem. Have you checked the door switches in the I/O to see if one is actually open? Another thing I have encountered is grease getting on the linear scale which will give you errors that are false. I wou
Electronics Forum | Thu Oct 22 03:10:49 EDT 2015 | myleb
I already check that sir, maybe its a loose > connection or board problem. maybe the ssr board was damaged. try swap the ssr between the A and B stage. Open the machine cover at AF/BF stage, it's the down left board with many connectors (have COV1
Electronics Forum | Thu Oct 22 04:45:32 EDT 2015 | myleb
Can you explain: 1. Is mc running normally before problem happens? 2. Any abnormality happens prior to problem? 3. Can you still check input/out put in machine adjustment meno? 4. Can you see all information in Ringload information? 5. If set bad be
Electronics Forum | Fri Oct 23 10:21:45 EDT 2015 | kurtiss
During production the machine Cycle Alarm ESC 3. When cycling power the error shows up again during a zero set after performing the Z1 zero set. When it errors out on zero set the only option that the machine allows is to power off. Thanks in advance
Electronics Forum | Sat Oct 24 23:26:43 EDT 2015 | thefinder
Hi. Have a problem with a QSA 30 machine. show me a error at the end of set up program. CAN'T ANC OPEN and then show me on the next row message. invalid place position x. if anyone has any suggestions please tell me.
Electronics Forum | Sun Oct 25 19:08:44 EDT 2015 | jc_smith
Hi everyone! I'm needing a 4 layer board for a DIY project. A friend recommended me to try with PCB Unlimited, since they are giving to students a professional stainless steel stencil for free with buying one of their PCB panel share. Has anyone prov