Electronics Forum | Tue Apr 27 11:53:36 EDT 2021 | dontfeedphils
When I was looking at Mirtec (4-5 years ago) I wasn't very impressed compared to Koh Young. It was easy to tell that Koh Young started with 3D and then added 2d features where needed, and that Mirtec had done the opposite. There's nothing wrong wit
Electronics Forum | Thu Dec 09 14:50:35 EST 2021 | emeto
The question is what exactly are you trying to achieve and at what cost? There is not unique recipe to answer this question, cause we don't know what product is running on this line. Sometimes very short line gives us much more throughput compared to
Electronics Forum | Fri Dec 10 11:19:50 EST 2021 | saberbouras
Thanks for reply, in fact, my question is how to calibrate the tool itself, it has some load spring and a gauge moving according to the tension of the mesh. I was wondering if I can make 2 different tension sets to have different comparing values, th
Electronics Forum | Wed Feb 02 08:11:03 EST 2022 | openindus
Thanks for the answer. Our camera doesn't even move during USC Park initialization. I assume it's a condition which isn't met to launch the sequence, but all the sensors seems to be fine. Could you send me the log (SECSDBUG.TXT) of your machine dur
Electronics Forum | Tue Jun 07 19:05:52 EDT 2022 | duchoang
First Article Inspection is always a MUST in SMT Process. If possible AOI would be added. We also have second operator/inspector to check on pick&place machine setup and use a program printout for inspector to compare/double-check with BOM and the ot
Electronics Forum | Wed Jun 08 03:09:44 EDT 2022 | pradeep14
Thank you. In our organization also we are following loading verification before starting the placement. But i want know before starting the placement during NPI/Proto Build, what are the system need to be followed to cross check with Pick & Place pr
Electronics Forum | Tue Jun 21 20:45:53 EDT 2022 | stephendo
Are you talking about in the machine as in the blowers? Or the exhaust? When CFM is an issue with an oven I think exhaust. With the blowers I check the oven with a profiler. I would think that the geometry of the heaters and oven would affect how m
Electronics Forum | Fri Aug 26 10:44:37 EDT 2022 | gfe
In the Mirae machine we can give an individual delay for each component, in this case the delay in Z is in all of them, the nozzle stays on top of the component for a long time, this happens in any program, could we have accidentally changed some con
Electronics Forum | Mon Jan 09 11:34:40 EST 2023 | tommy_magyar
How big is the board? What is the thickness? How populated is it? Is it warping in the reflow oven? If yes, does the oven have any support? How big is the pad compared to the component footprint? How thick is the stencil? Are the components checked b
Electronics Forum | Thu Jan 19 19:43:38 EST 2023 | smtusa
How does the Yamaha iPulse line compare to the Assembleon MG1? My friends had amazing experience with the MG1 and prefer them. I have never seen an iPulse in person. The heads and software look very similar between the two machines. The M2 seems
