Electronics Forum | Tue Jul 24 20:07:31 EDT 2018 | lraymond
24") The RD500V has three heaters and it uses a combination of hot gas and IR. The area heater can range from 3600 watts to 4800 watts with a bottom localized heater that is 1 000 watts which has adjustable z movement. The price of the RD500V series
Electronics Forum | Tue Jul 24 17:29:37 EDT 2018 | action_101
Hello, If anybody has a TECI PJ1A programmer that they no longer need or know of someone that might have one lying around then please let me know. We are willing to pay top dollar for one of these older programmers. This specific programmer was used
Electronics Forum | Fri Jul 27 13:51:53 EDT 2018 | vlad_saviuk
Hi, have some question: during solder paste printing I'm faced with problems on the edge of the PCB - solder balls on gold pads. During analisys we checked everything - change squeegee preasure, different cleaning cycles, squeegee speed - no effect.
Electronics Forum | Mon Jul 30 01:14:37 EDT 2018 | erici
Our DEK 265LT wont boot up with the DEK software. It says that the current version of the software can only run a 265GS printer, and to install the correct release of the software. Has anybody encountered the same problem? It just started happenin
Electronics Forum | Mon Jul 30 17:08:58 EDT 2018 | erici
Thanks for your reply. I did as per your suggestion, but the problem still persists. Here is the exact error i get whenever i re-start the pc "This programme can only runa 265GS printer. This machine has been indentified as a standard 265 printer.
Electronics Forum | Tue Jul 31 22:32:35 EDT 2018 | dekhead
Hardware dongle on back of machine is software key which may or may not be required for your software (depends on software version) and has nothing to do with the error you are experiencing. The hardware link to which I refer is on the Y1 backplane
Electronics Forum | Mon Jul 30 12:45:00 EDT 2018 | mdkmdr
Trying to get a sense of the push-pull going on between designers and manufacturers on the subject of 'one test point per net'. Getting a feeling like the new paradigm is doing all of the electrical tests as functional at EOL and relying almost comp
Electronics Forum | Fri Mar 08 09:52:53 EST 2019 | emeto
Rob, I have done it different ways. For the centroid you can do offline CircuitCAM or Valor or even pure Excell. I have used even pick and place machines files to extract data for AOI/SPI programming. These locations and coordinates are already there
Electronics Forum | Mon Aug 06 14:37:32 EDT 2018 | dleeper
What about some kind of surface mount clip? Solder the clips to the PCB and then insert the coil manually? IT adds a little labor but at least your coil won't move. For reference here's a company that makes that sort of thing. There are plenty of ot
Electronics Forum | Thu Aug 02 09:14:17 EDT 2018 | jeffallen662
Hey I'm having some issues with a YesTech YTV-1000 AOI machine. The machine isn't recognizing the X and the Y stepper motors. As far as we can tell nothing mechanical is wrong with the AOI. They are new motors and were suppose to have been programmed
