Electronics Forum | Tue Dec 08 16:53:41 EST 1998 | Ryan Jennens
Hey there Dave! We used to use a batch cleaner when we used water-clean paste. It was similar to a dishwasher, except that it had a digital menu for entering the number of wash cycles, water temp., amount of saponifier (we just used DI water),
Electronics Forum | Sat Nov 14 08:05:54 EST 1998 | Earl Moon
| | | | I believe that gold fingers on my circuit boards are being | | | | contaminated and need to clean them with some chemical | | | | solution. Any recommendations. | | | | | | | Chuck: What is the type and source of your contamination? Dave
Electronics Forum | Mon Nov 02 22:57:02 EST 1998 | Kelly Gossman
Micheal, What does your profile look like for the wave? What profile does your flux say you need? My guess is it is not your profile, our testing with solder balls found that the mask on the boards was the largest contributor to solder balls. Wha
Electronics Forum | Fri Oct 30 01:07:34 EST 1998 | Earl Moon
| I am a recently graduated Process Engineer. I am working for a company developing and manufacturing printed circuit boards. I am looking for a web link, magazine article, book, etc which describes the processes which happen at a board house. More s
Electronics Forum | Mon Oct 26 16:01:33 EST 1998 | tom Gervascio
| | I need some info on how to stop the bridges I'm having on | | radial and axial parts that are in the same place on every board. I'm also having problems with sot-25 bridging. I'm using a Electrovert E-pak. I tried leveling the machine,solder pot
Electronics Forum | Tue Oct 06 17:17:44 EDT 1998 | Chrys
| We are experiencing poor wetting on various components placed on a PCB with En-Tek coating. Is anyone else experiencing simular problems ? We have the following questions: | | 1. How can the thickness of the En-tek coating be measured? | 2. Is En
Electronics Forum | Tue Oct 06 15:41:14 EDT 1998 | Mike C
| | Does sombbody know what DPM rate a good and reliable SMT assembly line (incl. solder paste print, assembly and feflow soldering) has? | | DPM is Defects per million, usually measured on components. We run a process consisting of small to medium b
Electronics Forum | Mon Sep 28 10:12:53 EDT 1998 | Chrys
| Hello, | I need some users information about "Air knif" in wave soldering: | 1. Does it decreases bridging ? | 2. Is it self installed of a purchesed kit (if purchesed, who are the recomended vendors) ? | 3. Any other information about the issue. |
Electronics Forum | Thu Sep 10 21:44:48 EDT 1998 | Steve Gregory
| I'll stop talking to myself and wonder how big Steve G is doing these days. | Earl Moon Hey Earl! I was wondering the same thing about you a few weeks back when we didn't hear much from you...but, I'm doing okay. Been busier than a one-legged
Electronics Forum | Wed Aug 26 08:18:54 EDT 1998 | Earl Moon
| To All, | We have found several fake e-mail addresses on the Forum, most of them from one individual. We hereby announce that the following addresses are fake: | hello@smtnet.com | hi@smtnet.com | astounded@smtnet.com | thrilled@smtnet.com | The SM
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400