Electronics Forum | Fri Aug 23 03:13:30 EDT 2019 | winslow_p
Hi! What is the best soldering gun? I would recommend the Weller 9400PKS 120V. I think it is the best. I have been using it for more than a year and I was satisfied. If in doubt, check out the best Soldering Guns review at https://solderingironguide.
Electronics Forum | Sun Jul 14 16:46:38 EDT 2019 | rob1
I'm working on A DEK 265 Horizon and I need to convert it to right to left. I have changed the conveyor direction in software, however, the board stop position appears to be from 0 to 255 and I need it stop on the left hand side of the centre referen
Electronics Forum | Mon Jul 15 09:03:44 EDT 2019 | dekhead
It uses the same BS position regardless of feed direction. In right feed, it passes Board under the camera and when (board @ stop) sensor detects board has passed, drops the BS and reverses conveyor direction. There is "Right Feed Delay" parameter to
Electronics Forum | Tue Jul 16 16:15:14 EDT 2019 | dekhead
If a few extra seconds of cycle time won't hurt you, recommend putting at max (3.0 sec) it will cycle all the way over to the Board @ Left sensor before extending BS and reversing. Otherwise play with the timing and requirement may vary from product
Electronics Forum | Tue Jul 16 11:12:18 EDT 2019 | jamesbowers
Time to get more solder paste and have no clearer ideas on the matter than last time. Going through the smaller jars on Digikey these two stand out (as I think they did last time!): One's Water Soluble (that's the one I got last time) and the other
Electronics Forum | Wed Jul 17 02:31:30 EDT 2019 | mk15
I am looking for some help for where to look to fix this MY15E problem.After hardware initiation appear F-MOT-MSETDYN conveyor transport/1250: amplifier DC-link too high.Any suggestions? Thanks
Electronics Forum | Thu Jul 18 00:08:31 EDT 2019 | mk15
hank you for the tips. MOT boards have already changed. The sensor on the conveyor responds. In service mode, the WIDTH MOTOR - OK, HOLD MOTOR - OK, SET CONVEYOR - OK, only error TRANSPORT - F-MOT-MSETDYN conveyor transport / 1250: amplifier DC-link
Electronics Forum | Wed Jul 17 12:00:27 EDT 2019 | weglimir
Hello, Dek printer is starting successfully until "press System switch to initialize printer" but nothing happens when I press the button. What could be the reason? I've tried another pait of monitors with different system button, and it doesn't ch
Electronics Forum | Sat Jul 20 07:40:51 EDT 2019 | kylehunter
I have a 265 horizon. I've noticed that if we wait more than a minute or so after that screen appears, it does the same thing you describe. It's like it goes to sleep and doesn't register the button. So maybe try watching the screen, and right as you
Electronics Forum | Fri Jul 19 13:02:01 EDT 2019 | davef
Double-check me on this, but I don't believe that A-610 [IPC-A-610] requires side fillets on QFN solder connections, because the sides of most terminations are not plated. Plating on the bottom of the termination is sufficient for a proper solder con