Electronics Forum | Tue Jan 28 10:22:02 EST 2020 | emeto
Phil from the picture attached you see the challenge - there is no marking to show you which stencil is what. That is why people keep it in a box- to be able to see the number. I used VG for long years and I never liked them. Also with high changeove
Electronics Forum | Wed Jan 29 10:25:23 EST 2020 | dontfeedphils
VG foils are about 5mm thick and two in the rack takes up just under 20mm, so admittedly not a ton of space savings. That's not the only reason I like the VG system though. It takes multiple failure points (screen tension/mesh adhesion) and reduces
Electronics Forum | Mon Feb 03 13:17:26 EST 2020 | rgduval
When I had a MY500, I was told the only way to program it was through the interface software. The reason given was because of the algorithm/processing. You couldn't even do on the fly changes at the machine. I imagine they've continued that schema
Electronics Forum | Mon Feb 10 17:27:19 EST 2020 | SMTA-Alex
I used the older MYCam s/w to program the MY600. We switched to FactoryLogix for the MY700 printer. By the way, Aegis also supports Mycronic's Factorylogix installations. You can contact them about the crashes. It can, also, be from Windows. Sometime
Electronics Forum | Tue Jan 28 15:25:07 EST 2020 | emeto
If you refer to having wrong resistor or capacitor value, the only way is to automatically measure the part value. Mycronic pick and Place machines do it on the fly, ASM machines have feeder where part is measured....other main brands probably have
Electronics Forum | Tue Jan 28 15:27:57 EST 2020 | jede
Let me rephrase my question. How do you avoid having errors in your SMT set up? IE xxx part goes in feeder slot 55. We currently have our quality department do a machine check but small errors like this can still go unnoticed.
Electronics Forum | Wed Jan 29 03:11:18 EST 2020 | tamasmagyar
Barcode/scanner configuration can still lead to wrong parts mostly when changing reels. The root cause is still the line operator, because instead of scanning the newly set-up reel, he/she scans the old reel because 'it's easier' for them. I have wor
Electronics Forum | Wed Jan 29 07:10:19 EST 2020 | dontfeedphils
I'd recommend checking with the manufacturer of your SMT equipment and checking into the feeder verification solutions they have. Combine that with a buddy check and true first articles before the line can continue to run the balance of the job an
Electronics Forum | Thu Jan 30 20:41:05 EST 2020 | sarason
A solution that could placed on any machine is a first check that places a component in a fixed location and then the 2 pin component is read with a meter like a HP component measuring system. Similar for transistors and FETS. IC's are probably not s
Electronics Forum | Fri Jan 31 10:04:14 EST 2020 | emeto
Jinesh, My initial suggestion is you have too much solder past. Please try to reflow a few of these parts without solder paste. Colse aperture, put some tacky flux on this part location and give it a try. I bet you will not see any voiding.
