Electronics Forum | Fri Jun 26 00:33:08 EDT 2020 | victorzubashev
Hello everyone, Can you please recommend a sensor to measure (contactless) level of solder inside of the wave soldering bath? ideally it should be a sensor that can reliably measure distanceto the melted solder and provide distance (as a codified si
Electronics Forum | Fri Jun 26 14:27:51 EDT 2020 | victorzubashev
Hi Indhu, It could be multiple reasons but probably one root cause. metal nut might require reflow profile change- you need to check it with SMT reflow profiler. the part might be oxidized - you can check solderability or try to solder part using a
Electronics Forum | Fri Jun 26 15:42:15 EDT 2020 | wolverine55
We have a vintage 2007 JT wavesolder machine that we are having troubles with our solder pot heating SSRs not energizing. Please see the attached Word document that gives the details of our troubleshooting. I suspect that the TCM has gone bad, I co
Electronics Forum | Sat Jul 04 15:17:55 EDT 2020 | kumarb
Hi. The posted document cannot be downloaded. Can you repost using a cloud service or perhaps inside a zipped file? A free cloud service, but will auto-expire after 7 days of posting is: https://wetransfer.com/ If possible, try both - post on th
Electronics Forum | Fri Jun 26 22:13:42 EDT 2020 | jmelson
Can anybody who has a PPM-retrofitted Quad IV C tell me what they think? I'm still going around in circles trying to decide what to get. I am doing some TSSOP and QFP parts with 0.5 mm lead pitch and 0.65mm, and my current machine isn't accurate en
Electronics Forum | Tue Jun 30 18:07:34 EDT 2020 | daisy_mu
Hi Phill Thank you, It´s a possibility because that model has many false calls and real defects, but only in one component. A while back we had a similar problem and we changed the component number to a new one, and the cycle time was better, but th
Electronics Forum | Thu Jul 02 17:46:46 EDT 2020 | emeto
There articles about mixed metallurgy and possible quality issues with this kinds of joints. As it is just repair, I would assume it is a local fix, so you should probably go Pb-free paste. If you want to reflow the board I would re-ball the BGA to m
Electronics Forum | Sat Jul 04 15:34:12 EDT 2020 | sara_pcb
Hi, I am designing a PCB which consist of Instrumentation Amplifiers, Programmable Gain Amplifiers, Switched Cap Filters, FPGAs & many ADCs. Involves low level Analog signals. How to patrician the layout so Analog & Digital signals do not interfere.
Electronics Forum | Mon Jul 06 22:25:51 EDT 2020 | jmelson
I'm looking at a Samsung CP45FV on auction. There are some mystery parts shown in the pictures, which I have attached. Two boxes with 3 lenses each. Does anyone recognize these? I'm hoping they are not part of the flying vision camera, if they are,
Electronics Forum | Thu Jul 09 10:51:54 EDT 2020 | mcbasol
Hello everyone, I'm in a manufacturing environment with a middle mix of boards, and some mid volume. The cards are our design and the most diffucult pakage is TSSOP-14, QFP-128 and 0603. So, these days we decided to buy new printer? But, we have stac