Electronics Forum | Wed Dec 23 22:34:22 EST 2020 | bobpan
Hello Marcelo, When you initialize the system in central controller...does it see mvs? Will a different job that you ran before work or does the same error happen? When do you see this error. You can email me at http://www.precision-repairs.com if y
Electronics Forum | Sun Jan 17 10:27:01 EST 2021 | ecogroup
Thanks for replying Bukas...few days prior we found out it was the conveyor IF board. Changed it, all the contactors now engage. But now have these errors: Opened [SYSTEM] file is created by #1 machine. No command resonse from handler. (0x1000)
Electronics Forum | Wed Jan 06 11:05:13 EST 2021 | greezmky
Thank you rtmitchell, being unfamiliar with the system, I missed that the end is slightly nicked. I pulled a dog out of a machine that has been cannibalized, I verified that it was straight and not nicked, and installed it in our production line mach
Electronics Forum | Tue Jan 05 21:01:40 EST 2021 | brianjones
We are looking at setting up a memory module conveyor belt with a stacker and de-stacker. I will need to handle DDR3 and DDR4 Long DIMM and SODIMM. I will be mounting an image camera under and over the modules. Looks like an edge conveyor would be be
Electronics Forum | Tue Jan 05 21:28:18 EST 2021 | rmitchell
We have an old MPM accuflex and both camera lights stopped working this morning during production. We tried the bulbs but the new ones did not work either. Any ideas on this? I don't think we have a manual but will keep looking in the dungeon. Plea
Electronics Forum | Wed Jan 06 22:10:04 EST 2021 | emeto
Measure if you have power where the light should go. Don't remember but it is probably 5V bulb/12V buld(it should say on it). if you have power, measure the bulb. I am not sure how new you new bulbs are.
Electronics Forum | Mon Jan 11 17:19:31 EST 2021 | rmitchell
Problem resolved- The machine camera had crashed when the operator put the PCB in upside down (this was kept secret until intense water boarding). The crash seem to take out a chip on the vision processing PCB. It was visually damaged and looked lik
Electronics Forum | Thu Jan 07 03:32:19 EST 2021 | ravikumargv
Dear All, In S27HM siplace machine PCB camera images not display and when i try to teach feeder potion or fiducial position PCB camera light is glowing but, images not showing in monitor, kindly help what is the root cause for this issues... Regard
Electronics Forum | Thu Jan 07 14:21:43 EST 2021 | nicole09pay
I'm new to SMT circuit design and I'm wondering is that okay to connect a SMD component to a transmission line (microstrip) which has a width larger than that of the component? My simulation results show that its fine but I'm not sure if it causes si
Electronics Forum | Tue Jan 19 19:41:09 EST 2021 | rgduval
Double check your p/n and your datasheet, and with your supplier. I had this happen one time, though it wasn't with flexi-term parts. Mine ended up being palladium plated end-caps (my buyer and receivers had all missed the applicable suffix issue o