Electronics Forum | Wed Jun 09 23:58:59 EDT 2021 | SMTA-64387687
The electrical test, on those older machines, wasn't very exact. Try to expand the tolerances, 25-30% for caps and 10% for resistors, and see if that solves your problem. Also, if I remember correctly, if you go into the layout and single-place the c
Electronics Forum | Thu Jul 01 18:05:16 EDT 2021 | cyber_wolf
2050's are old and no longer supported. If a major component fails you could be in trouble. Control boards etc....
Electronics Forum | Thu Jul 08 23:52:24 EDT 2021 | tey422
I would suggest getting KE-2060 or KE-2080 instead. It has better camera and easier programming if you are working with fine-pitch components such as QFPs & Micro BGAs.
Electronics Forum | Wed Jun 23 03:40:11 EDT 2021 | pradeep14
Hi all, How do we select components loading feeders?? Is there any specifications or chart to select the feeders on the SMT lines during programming.
Electronics Forum | Thu Jul 01 13:41:25 EDT 2021 | oxygensmd
For example, I am getting them from KHJ. Green version is really fine - have strong adhesive. http://www.khj.com.cn/ProductDetail/3103332.html
Electronics Forum | Thu Jul 01 16:16:10 EDT 2021 | willkillum
https://www.ebay.com/itm/184906151272?hash=item2b0d43f568:g:GsYAAOSwhfZdbjnU
Electronics Forum | Tue Jul 13 11:21:28 EDT 2021 | stephendo
You may have to use an adaptor board. A small board with one footprint on one side and the other on the other side. Do not assume that the pin outs of the two parts are the same. I have seen smaller parts with a different pin out than the bigger part
Electronics Forum | Tue Jul 13 19:20:51 EDT 2021 | emeto
Just give them triple the price and they will love to make re-design. If you do what was suggested with the additional PCB, price might be close enough to triple.
Electronics Forum | Tue Aug 17 08:34:31 EDT 2021 | kumarb
Hi. What are you looking for exactly? We have been sourcing various electronic parts offshore for the past 20 years. Perhaps can help with suppliers.
Electronics Forum | Tue Sep 07 15:23:20 EDT 2021 | majdi4
1 ) Component is not Rohs : Material analyzes confirm that they contain lead over than < 1000ppm 2 ) upper piston blocked after reflow 3 ) wetting was unstable and slow due to heat transfer will you produce with ??
