Electronics Forum | Mon Feb 28 21:30:34 EST 2022 | emeto
Couple notes here: 1. Try to shoot for 250C peak temperature. 2. Use all your 10 zones in profiling for more accurate profile. You should not reach your highest temp in zone8. Try to reach it in zone 10. 3. Go quicker. Your profile might be too long
Electronics Forum | Wed Mar 02 04:47:41 EST 2022 | shrikant_borkar
Dear All Hopefully you got the situation on SIPLACE D1i and SIPLACE D2i. Pickup up Place machines. Is the lead bend upward of SMT transistor detection is possible on this machine? If not is it possible to get it detects by optimising it's windows.
Electronics Forum | Wed Mar 02 13:15:16 EST 2022 | chris007
I am currently working on a manufacturing flow where some PCBA are processed with reflow oven (after being baked before processing), then cleaned with bath, then passed into contaminometer, passed into AOI. The point is after all of this, if AOI dete
Electronics Forum | Wed Mar 02 22:11:30 EST 2022 | travishemen
I have successfully revived a dead hard drive by buying an the exact same model and swapping the circuit board from the new an presumably good hard drive to the drive I'm having trouble with. I have done this twice on hard drives that were between 1
Electronics Forum | Mon Mar 07 06:44:39 EST 2022 | SMTA-64386201
We previously labelled PCBs after assembly but before AOI. Now we need to trace panels during assembly as well, so have the need to apply labels before the assembly process starts. Our stencils are thus not stepped to accommodate labels. I suppose t
Electronics Forum | Mon Mar 07 15:03:57 EST 2022 | emeto
I wish traceability was not part of our job. If I have to pick, I will laser etch barcodes rather than use labels. Small footprint and fine pitch parts will always hate the label when you print paste. Pick thinner labels, keep away from problematic l
Electronics Forum | Thu Mar 10 10:35:39 EST 2022 | paddymanoj
I have a used MYDATA Pick & Place Machine. It is MY9 and year 2000 Model (almost 22 years old). I have 5 extra magazines of this Machine (MY9). I want to know, if I can use these Magazines with any other latest MYDATA model. If someone can tell me, w
Electronics Forum | Thu Mar 10 21:16:38 EST 2022 | proceng1
How far from apertures is the label supposed to go? I'd say 1 inch is plenty. 3/4 inch might be plenty also. Do you have the ability to measure paste height? I'd say place the label on one board and print two. Is there an appreciable differenc
Electronics Forum | Mon Mar 14 20:05:30 EDT 2022 | cbeneat
We are still running an EKRA X5. 2008 build. 1,366,000 cycles. Being swapped out in the near future with an X5 Pro. But we're going to hold it for emergencies. We've found the older X5's are pretty bullet proof. Just keep up on the maintenance.
Electronics Forum | Tue Mar 15 17:47:24 EDT 2022 | guyt
Hi, Has anyone had a issue with a MyData my12 dual camera system, were the calibration always shifts up after a few hours of use. It's not the mechanical calibration. it is like the machine loses it's software calibration co-ordinates ?? Any ideas