Electronics Forum | Tue Jul 06 17:03:46 EDT 1999 | Earl Moon
| Is anyone aware of some guidelines regarding through-hole in SMT pads? One of our designers wants to add through-hole leads in some SMT pads for an inductor. The size of the hole is 0.032 inches and takes-up approximately 25% of the pad area. Th
Electronics Forum | Tue Jul 06 18:16:14 EDT 1999 | Boca
| | Is anyone aware of some guidelines regarding through-hole in SMT pads? One of our designers wants to add through-hole leads in some SMT pads for an inductor. The size of the hole is 0.032 inches and takes-up approximately 25% of the pad area.
Electronics Forum | Thu Oct 08 14:04:04 EDT 1998 | Kris Ewen
Manish, I've seen similar phenomenon when processing CSPs on our cards. In our case, we were placing the components over the opening to in-pad blind vias. Due to poor drilling and plating processes by our board suppliers, volatiles were outgassing
Electronics Forum | Tue Dec 16 06:42:51 EST 2003 | Kev
I am having problems achieving correct pre-heater temperatures with our Hollis solder wave. Our original "Verification Golden board" program uses a conveyor speed of 5ft per minute and pre-heat temps of 300, 350, 400 respectively. Our "golden Board"
Electronics Forum | Tue Apr 13 09:46:39 EDT 2004 | davef
Now, that's different. We misunderstood the problem from your original descrtiption. We thought the voids were showing at the via in the pad. Now, we understand the voids appear to be in the solder balls. Suggestions are: * Search the SMTnet Arch
Electronics Forum | Mon May 24 06:00:23 EDT 2004 | johnwnz
call me picky but doesn't hydrogen combust? maybe soemthing you could do is look at your process and your products and decide if you actually need to run in N2. Yes ok I can hear the crys now but seriously, for the vast majority of things if you have
Electronics Forum | Fri Jul 29 19:12:30 EDT 2005 | Jason Fullerton
In the true sense of the term, tombstoning can only occur during reflow. Now, if your solder joints are cracking during thermal cycling and opening on one end you still have a problem - it just isn't "tombstoning". What laminate are you using on yo
Electronics Forum | Mon Mar 29 18:17:48 EST 2004 | kerryn
It should be noted that some of the main reasons to change from manual cleaning to automated stencil cleaning are: � Manual cleaning is not consistent � quality is totally in the operators hands � Contamination left on the stencil and in the aperture
Electronics Forum | Thu Jul 08 15:38:27 EDT 1999 | Earl Moon
| Thank you all for your replies. Thanks to your replies and backup from the IPC-SM-782A (section 3.6.3.2) and James Blankenhorn's "SMT Design Rules & Standards," the designer has agreed to provide adequate clearance between the via and the pad. |
Electronics Forum | Wed Dec 09 10:02:10 EST 1998 | Earl Moon
| Does anybody out there have any special insights into utilizing no clean paste in high frequency RF applications? I would imagine there may be some issues with solder balls that would affect functional test (Earl, do you have something for me here?
.gif)
