Electronics Forum | Tue Oct 10 14:46:35 EDT 2023 | tommy_magyar
We order bespoke carriers for some of our products, made of Durastone, however, a 1.8-2.0 mm thick FR4 sheet will do the job you require too - as previously suggested.
Electronics Forum | Tue Oct 10 23:22:11 EDT 2023 | unsung
I've fix alot of these samsung machines. Do you have a picture of the error or screen that says not loading program. My email is marlonquiroz84@gmail.com ( also the fuses should be located on the back of VME card green color smt chip. ( I highly doub
Electronics Forum | Wed Oct 11 18:12:55 EDT 2023 | alexv
I don't think it's a stencil issue. You have an identical inductor next to t=it, that's perfectly straight. You have a problem in that location. I've seen some inductors be affected by slight magnetic forces in the reflow oven. Try to rotate the boar
Electronics Forum | Fri Oct 13 10:36:51 EDT 2023 | barty
Hello! To download TikTok videos and then watch them without internet access, https://savetiktok.org is the perfect solution. This service allows you to download videos and save them to your device, allowing you to enjoy the content even where there
Electronics Forum | Fri Oct 13 19:01:46 EDT 2023 | crystalw4280
I have an old Juki 2060 The electors were replaced on some heads that were disabled. Now we are showing some of the same errors with those heads. Does anyone have any suggestions for possible cause that would make this happen again. Another warning
Electronics Forum | Tue Oct 17 08:05:22 EDT 2023 | unsung
I don't see your email in my inbox sir. It's a lot to write. Check all your power supplies make sure all of them light up in your machine and Check the Main Start Switch if it correctly works the ignition green button switch you should here a thumb n
Electronics Forum | Wed Oct 18 15:49:51 EDT 2023 | spoiltforchoice
The only thing I can add to this is that I think I have seen a screenshot/video of Hanwha placement software that showed (or appeared to) manufacturer part numbers being used on the machine and alternative handled on that same screen. That may have b
Electronics Forum | Sat Oct 21 17:41:05 EDT 2023 | basil_rv
Hi all! While operating the JUKI JX-350LED, error E600016 (Since the Z-axis is descending, it cannot operate) appeared. During initialization, this error appears, although all heads are raised. Rebooting and turning off the heads did not help. Wha
Electronics Forum | Mon Oct 23 15:03:19 EDT 2023 | davemccabs
Hi everyone, We just acquired a MPM Ultraprint 1500 and dont have manuals for it. It's running SigmaPro 32 v6.3 software. Would anyone please be able to share any manuals for it? Hopefully more than just the operator manual. Thank you!
Electronics Forum | Wed Oct 25 19:36:41 EDT 2023 | samlam
The process of med spa staffing is intricately outlined in the discussions on https://valhallamedics.com/navigating-the-challenges-of-med-spa-staffing-the-role-of-valhalla-medics/ . The page unveils the nuances and challenges inherent in med spa staf