Electronics Forum | Thu Mar 21 12:09:28 EDT 2019 | alexcouto
Hello Bukas, thanks again. Since at an early stage I switched heads # 1 and # 6 and they are not compatible, then I went through the manual and figured out why. in order to start at the beginning and check that it had not damaged anything, I put the
Electronics Forum | Mon May 13 02:14:04 EDT 2019 | tsvetan
All these generalizations are non sense. What real cph you will receive depend on many factors: - paths optimization - what number of feeders are used - what number of nozzle changes has your job - how fast is the recognition for small and big part
Electronics Forum | Wed May 08 07:19:03 EDT 2019 | youngbuck
Hi Sankar, I have had experience with the SX and X2 so I'm not sure how similar ours is to yours but i can give you some suggestions. 1. As Thomas said you could do a vaccum check and make sure the 4007 nozzle has around the same settings as the ot
Electronics Forum | Mon Jul 08 18:45:53 EDT 2019 | assuredtech
Would you happen to have the Jig used to check that the component itself is in spec with UIC's general specifications? 1.) Component in spec. 2.) Correct 2.5mm pusher on the feeder / dispense head. Also set the conditioner guide where the comp enter
Electronics Forum | Thu Jul 18 17:38:27 EDT 2019 | rgduval
Not swapping out feeders....swapping out magazines. It only works well if you have enough extra mags to load all the feeders on. And is a viable solution if your position limited on your machine. Before the advent of Aegis feeders for My machine
Electronics Forum | Thu Aug 08 11:04:48 EDT 2019 | btfonseca
Hi everyone, I was recently trying to troubleshoot a bad floppy driver on our QSV-1, which actually worked, I was able to read floppy drives but for some reason it all went downhill when one of the green LED's turned off and another red LED turned on
Electronics Forum | Tue Nov 19 21:38:39 EST 2019 | zack
Hello, The first thing that you need to do is to make process mapping about this incident, so you can exactly determine all factors and observable changes happened during 2 weeks of timeline difference. According to my experience, if all equipment
Electronics Forum | Wed Dec 04 07:35:08 EST 2019 | proceng1
We also have a few customers that seem to buy the cheapest LEDs available and provide them for the build. We've had complete reels that had obviously been exposed and oxidized. You can try a solder with a more aggressive flux. How long is your pro
Electronics Forum | Fri Dec 27 12:53:38 EST 2019 | rgduval
yeah...I never had airflow volume problems with Hellers. When I had to build the system I was referring to, we had an old Speedline oven, and the way it was configured if you didn't provide enough airflow to the outer cavity, the blowers would overh
Electronics Forum | Thu May 21 12:53:38 EDT 2020 | spoiltforchoice
A cheap piston compressor (like you might use in a garage) should be rated such that it has ~50% duty cycle, you don't want it running continuously. They are very affordable but do switch on and off between two essentially hardwired setpoints. The b