Electronics Forum | Mon Sep 14 20:19:33 EDT 2020 | kumarb
Hi. 1) recommend to phone up Heller for assistance on this case 2) using the wakeup profile, can you confirm if the problem remains or not when you skip the warm up of zone # 2? 3) each zone is based on 2 heaters (this is what we have on our 1809e
Electronics Forum | Mon Oct 05 07:48:12 EDT 2020 | tamasmagyar
Hi Smitty, I am currently using Manual Lock Red-E-Set, and never had problems with damaged components. Although at my last workplace, we used VarioGrid, and encountered same problems as you. I suggest checking the pins on the support tools(s) you h
Electronics Forum | Tue Oct 20 05:47:42 EDT 2020 | Mike Konrad
Most often, dull solder joints (post cleaning) is a result of the cleaning chemical. Most (not all) modern cleaning chemicals are equipped with corrosion inhibition agents which prevent dulling. Check with your chemical supplier to see if your specif
Electronics Forum | Fri Nov 06 20:43:58 EST 2020 | jmelson
Does anyone have schematics for the PC board inside a Quad IQ feeder? I have one that worked a few days ago, but now gives me blinking lights and doesn't move. Or, do you know what to do when it won't move? I have checked the contacts and the feeder
Electronics Forum | Thu Nov 26 03:59:59 EST 2020 | ravikumargv
Dear All... Greetings.... Recently My S27HM machine MC had problem and i replaced another same S27HM machine MC and updated BIOS and installed RMOS1&2 after Distribution successfully completed power off the machine and power On the machine, afte
Electronics Forum | Thu Dec 24 14:37:58 EST 2020 | marcelorotofrance
Hi again Bob. I have checked the machine and it resulted that the files of that program were corrupted in some way. All other programs worked fine. I have a back up copy of all progs in a different drive so I fixed it. Two days ago there was a huge b
Electronics Forum | Thu Mar 25 23:23:00 EDT 2021 | llawrence
The QFP pitch is 0.5mm. Pad size is 1.475 x 0.3mm, and the new aperture size is 1.32 x 0.22mm. I'm not sure about whether or not it is lasered, but on the newly ordered stencil I selected the polishing option. Looks like the pad width is already 2/3
Electronics Forum | Wed May 19 20:11:21 EDT 2021 | compit
I have two machines - Emerald-X and Topaz-X. I cleaned (and changed Koganei electromagnets) only in Topaz-X - Emerald-X is in very good condition :) But my Emerald-X have SF (not FNC) heads. If head 1 is OK - change the relays with head 2 and check.
Electronics Forum | Mon May 24 05:56:59 EDT 2021 | bukas
hello James, you should be getting error message " no pneumatic pressure " when trying to get machine into READY state with no air supply. maybe you should check HDD health. while you are there, make HDD backup; and if machine uses ATA driv
Electronics Forum | Fri Jul 09 11:39:27 EDT 2021 | stephendo
I was once part of a conference call with a component manufacturer. The call was starting to get heated as the manufacturer was certain that we were not storing the parts properly and we knew that we were. Then one of their people asked how many we