Electronics Forum | Thu Jan 27 05:24:06 EST 2000 | Scott Davies
From personal experience, I agree with Dave that pre-owned equipment is often a more favourable option than the OEM route...provided that the equipment is purchased from a reputable source, supported with some kind of warranty, and be aware that some
Electronics Forum | Wed Jan 26 12:22:52 EST 2000 | Mikel Rodriguez
The diode doesn�t appear completely broken. It takes a bit white color (cristal break, I think), instead of the normal red/orange. It works like a 20K-200K ohm resistor. !The diode can be working properly and sometimes change to bad! I think it may
Electronics Forum | Thu Jan 27 20:36:13 EST 2000 | Dave F
HJ: Your best chance of running your boards with a single profile is with ovens from the established suppliers (ie, BTU, Conceptronics, Heller, Vitronics, etc). They are experienced in robust control system designs. Stepping aside from that, consi
Electronics Forum | Wed Feb 02 15:12:44 EST 2000 | Chung H. Park
Mr. Kim: The answer to your question depends on the type of mix you are dealing with. Here is the approach you should be taking to answer to your question yourself: 1. Establish the reflow process specifications for products. 2. Profile your p
Electronics Forum | Tue Jan 25 15:16:35 EST 2000 | Kim Sterling
SMTNETTERS - I apologize in advance if anyone feels this message is too commercial, but we have been receiving inquiries as to APEX's future after 2000, and just wanted to let the industry know that the event will continue. We have the following c
Electronics Forum | Tue Jan 25 13:06:47 EST 2000 | Bill Schreiber
When switching from cleaning RMA to a no-clean flux, one area that is commonly overlooked is the stencil cleaning operation. Stencil cleaners that are effective in cleaning RMA often fail when cleaning no-clean (especially alcohol cleaners). Pallet
Electronics Forum | Sun Jan 23 03:07:16 EST 2000 | Robert Steltman
We are experiencing 2%+ dropout on one particular SOT23 device. This seems to occur during the actual pickup phase. I have made sure that my pickup position and height are correct. If I single step through the forward feed of the component, viewing i
Electronics Forum | Fri Jan 21 18:47:14 EST 2000 | Ashok Dhawan
This massage is for clarifications on storage and handling of Moisture sensitive parts: Does chip resistors,capacitors and inductors need vacuum packing during usage life? For repacking of FPDs to limit reuse, is it necessary to use vacuum seler or s
Electronics Forum | Fri Jan 21 05:18:55 EST 2000 | Dean
If at all possible avoid mirror assembly BGA designs. It has a higher failure rate when compared to non-overlap designs (life testing). In addition, from a rework point of view, X-ray inspection yields no help when a failure occures. You can't det
Electronics Forum | Thu Jan 20 12:10:29 EST 2000 | Dave F
Hany: I have never understood why the add-on boards in PCs have gold plating on their connectors. In the military and in avionics, they require gold on connectors to protect from wear and corrosion. But PCs ave very different. PCs: * Are obsolet