Electronics Forum | Wed Feb 09 11:37:26 EST 2005 | pjc
Technical support cannot help with this issue, especially Electrovert tech support, those guys only know soldering and cleaning machines. Contact Jim Kaler at Camalot Applications Support: 603-641-8666 ex7208 or jkaler@speedlinetech.com Tech support
Electronics Forum | Thu Feb 10 09:01:40 EST 2005 | russ
I have done that also, It does work well. One issue we had was that the mask didn't come right off during the first wash cycle since it was put on much heavier than the mfgr suggested (.01"). We had to soak them in some water first to soften it up
Electronics Forum | Wed Feb 16 14:47:04 EST 2005 | Valerie
Mike, To answer your question, Yes we have thru-hole parts on the boards that we converted to double-sided reflow, we use pallets to select solder the leads. I suppose Masking would work, but that's using a lot of mask. Can I ask, whats preventing
Electronics Forum | Tue May 06 11:56:56 EDT 2008 | joeherz
We have a board that uses 0402x4 RNET packages that we are having a difficult time getting to solder consistently. Paste deposition is fine (using AIM WS353) and profile is dead-nuts. I'm starting to wonder if this is something that we're just goin
Electronics Forum | Mon Mar 06 17:17:13 EST 2000 | gary
I need a little help with RF and Rogers 4003 board material. My background was in digital and now I need to set up a new line to make small RF products (.5" x .5" or smaller). I want to find out about board platings, finishes/maskings and reasonable
Electronics Forum | Mon Mar 06 17:17:13 EST 2000 | gary
I need a little help with RF and Rogers 4003 board material. My background was in digital and now I need to set up a new line to make small RF products (.5" x .5" or smaller). I want to find out about board platings, finishes/maskings and reasonable
Electronics Forum | Tue May 08 21:13:04 EDT 2001 | Paul
My company is a low-volume high mix contact electronic manufacturer. We are currently looking at purchasing a pick and place machine that is capable of mounting such new components as microBGA's and other CSP's at such ball pitches as 0.5mm for examp
Electronics Forum | Wed Feb 09 11:50:55 EST 2005 | mrduckmann2000
Pete, I started with the App engineers, they had me try a 21g needle then a 23g needle then a 25g needle. The tech's are the ones suggesting that I slow the pump down to half speed and try a 27g needle. The needles are $150 a piece.....I now have
Electronics Forum | Wed Feb 09 12:28:58 EST 2005 | Valerie
We have been pretty successful with screen printing glue, however the smallest component we now glue is a 0805. We had many problems using our Gemini II to put down glue dots for a 0603, so we altered the pads to do double-side reflow. As our own int
Electronics Forum | Wed Feb 09 12:31:54 EST 2005 | russ
We are not doing this right at the moment but I have done it with great success. Of cource it depends on your pad layout we have a 20 mil gap in between pads, we printed at 10 mil wide with a 5mil stencil. I will try to find the glue we used, I kno
.gif)
winsouce.jpg)