Electronics Forum | Mon Apr 29 01:29:29 EDT 2013 | aemery
If your current problem with the conveyor speed was caused by the SMEMA issue, maybe you have a Board #1 problem. The SMEMA communicates to the computer through Board #1. The input signal from the speed encoder and the output analog voltage to the
Electronics Forum | Mon Nov 13 08:24:03 EST 2000 | G. English
Richard, From your description of the IC, as Wolfgang indicates it sounds like a 20mil pitch device, the aperture design really depends upon your solder paste particle size, we use a type 3 solder paste with a mesh size of �325 / +500microns. This is
Electronics Forum | Wed Nov 15 11:00:35 EST 2000 | Finepitch Services
"depending on your pad design"... To me, Wolfgang gave you the biggest secret... I guess he meant the real pad width you get on your board is the start point. Get the average measurement in mils and then cut it from the sides at the percentages he h
Electronics Forum | Mon Oct 26 02:00:36 EDT 2020 | chucherry5076
https://www.jrpanel.com/R The heat generated by electronic equipment causes the internal temperature to rise rapidly. If the heat is not dissipated in time, the equipment will continue to heat up and the components will overheat and fail, resulting
Electronics Forum | Thu Apr 17 07:47:07 EDT 2014 | emeto
Hello all, does anybody know How to set paralelism on Electrovert OmniFlex 10? I couldn't figure that out on my own, so please help.
Electronics Forum | Tue Feb 11 10:31:20 EST 2020 | emeto
Values and range definitions on your profile attachment are for LF paste not for Tin Lead. Please recheck and redefine, so we get the correct values. Also, which location is the QFN?
Electronics Forum | Tue Feb 11 10:41:30 EST 2020 | dunks
We had this problem at my old job. My understanding (from googling this problem previously) is that the exposed leads on the side of the qfn are not tinned and are not required/designed to have a fillet. Someone correct me if I'm spouting lies.
Electronics Forum | Tue Feb 11 10:59:31 EST 2020 | dontfeedphils
I was going to say, technically it's BTC, so I don't believe it needs a fillet, only evidence of wetting.
Electronics Forum | Tue Feb 11 15:17:49 EST 2020 | emeto
Your profile should be close to this.
Electronics Forum | Tue Feb 11 09:26:57 EST 2020 | astarotf
Hi everyone I have problems welding QFN components in a 10-zone reflux oven, we cannot make a welding fillet that covers the entire QFN pin. Currently we use paste T4 - 63Sn / 37Pb. I enclose the curve of the oven profile. Any help or support on this