Electronics Forum | Mon Feb 23 12:22:32 EST 2004 | esoderberg
I have an MPM SPM and two Ekra E4 screen printers. I have always run them dry with vacuum. I am also using no-clean paste and have not had a problem. The volume I run per day on the machines is 4 - 6,000 bds
Electronics Forum | Mon Jun 14 09:01:09 EDT 2004 | jdumont
Morning all, can anyone point me in the right direction. Recently our NO2 generator (bought before I was here) for our IC parts cabinets went bad. It will cost around $6000 to replace. I am just looking for some tech papers or anything to help sub
Electronics Forum | Fri Apr 27 11:47:28 EDT 2007 | BKG
We are looking at obtaining a TP9-UFP and I have never worked on mydata before. Most of my experience is on Philips and QUAD. Opinions on practicallity for low volume high mix application? What is the actual CPH? I see it is rated at 6000cph, but in
Electronics Forum | Thu Dec 10 11:07:48 EST 2009 | Lorena Flores
Hello! I think the point here to have a reliable counting system. No matter if it is given 5000 out of 5000 or 6000 out of 5000. What Jesus means is that there is a problem because the qty that the label says after the reel is counted doesn't match
Electronics Forum | Fri Apr 16 12:23:40 EDT 2010 | shawnvike
We are looking at buying a new (or used) oven for low-mid volume Pb-free production. I have looked at the smaller Hellers, BTU, vitronics, etc. and I am also looking at the Manncorp CR-6000. I want at elast 5 zones, top and bottom, air (no N2) pi
Electronics Forum | Thu Feb 24 23:11:51 EST 2011 | kemasta
HI I have this BGA short issue, I took x-ray image, the solder ball having big void. We suspect the pad on BGA was oxidie. Reject percentage quite low, only 5 out of 6000. But after the BGA re-ball, is work fine. Anyone have any idea to trobleshoot
Electronics Forum | Wed Aug 17 12:14:52 EDT 2011 | emeto
We hacve Juki and I have to admit that they are very good machines. These machines are not very fast(I don't know how different is 2080. 1080 aned 2060 are almost the same and their real speed is about 6000cpm/h. Besodes that fact the machines great
Electronics Forum | Fri Dec 12 02:11:35 EST 2014 | acepa
We have 6,000 TI BGA's to remove from a PCBA and reball for reuse. TI DaVinci BGA, DIG, Media, 284 ball part number TMS320DM8148SCYEO Does anyone have a formal repair procedure or knowledge of such rework for such a part they would be willing to sh
Electronics Forum | Wed Jan 05 17:19:56 EST 2022 | emeto
We use Benchmark Smartsonic 6000 for the last 20years. Recently evaluated replacement. Candidates we picked now are close loop systems, smaller footprint and use smaller tanks. Cleaners evaluated - Kolb-PS300, Systronic cl420 and DCT inkjet 388. We p
Electronics Forum | Wed Apr 18 10:58:43 EDT 2001 | CAL
We use Arlink for our portable SMT work surface. http://www.arlink.com. Now for question number 2: "Are portable SMT workbenches out there with stencil storage? " I hope you are referring to frameless stencils or even better Micro Stencils- A hollow
