Electronics Forum | Mon Aug 21 13:12:27 EDT 2023 | ronh22
We have a Juki KE-2080L that is going through CMOS batteries. We just installed our 2nd one in a couple of months. Other than maybe I have a bad battery any ideas why they would die so fast?
Electronics Forum | Tue Dec 13 21:38:14 EST 2022 | duro
Stephen, there is one CMOS battery on PC board. I haven't check it, but time and date on PC is correct, so I guess it should not be problem. On VME controller is another CR2032 battery (based on VME datasheet it is for some RAM memory). That battery
Electronics Forum | Tue Nov 14 09:43:10 EST 2000 | jason
Hi, I have a question about charging up batteries. I have two batteries in series, they are NiMH PCB mounted rechargable batteries that are used for battery backups etc. I want to be able to recharge these batteries, so I wont have to buy new ones
Electronics Forum | Tue Feb 21 13:40:11 EST 2006 | slthomas
The SuperMole Gold uses a proprietary rechargeable Ni-MH battery design and while it's a nice unit and I'd love to have one now, I wouldn't want to have to replace the battery. In other words, it's going to cost you. FTR, the last one I used was rou
Electronics Forum | Fri Mar 18 16:55:08 EDT 2011 | asksmt
Hi All, i am soldering battery to the back side of PCB and there are some TH Pins comes right BELOW the battery body. Can you please suggest any kind of insulating material / tape which i can use and the insulator between solder pins and battery bod
Electronics Forum | Fri Mar 03 20:45:58 EST 2006 | KEN
I have used KIC data acquisition equipment for over 11 years. Slim kic, sideKic and Kic2000, prophet etc... The 9 volt battry changes in seconds. Gimme a break. The internals don't reach 54Celsius. If it came down to batteries, I bet KIC would t
Electronics Forum | Sun Aug 31 23:53:40 EDT 2003 | Andy
Does any one know where I can obtain firmare for an HTI-7 screen printer. The internal memory battery went flat. I replaced the battery but the firmware was lost.
Electronics Forum | Thu Jun 02 19:24:31 EDT 2005 | davef
Your link doesn't download. "1071" is not a valid part number on Keystone's site. "Battery clip" is not a valid part name on Keystone's site.
Electronics Forum | Fri Jun 03 03:27:36 EDT 2005 | Rob
http://www.keyelco.com/pdfs/prod03-coinholders.pdf Bottom of page 2 of 3. There is a reasonably large heatsink function on one of the pins due to the size of the Anode/battery spring clip.
Electronics Forum | Fri Jun 03 12:43:19 EDT 2005 | ratsalad
Rob, The first thing I checked was the profile, just for that reason. We've profiled the board with thermocouples on both sides of the battery clip and the profile looks good.