Electronics Forum | Sun Sep 15 04:45:22 EDT 2013 | jandon
Cleaning and lubrication requires maintenance training. You can really break something if you don't know what you are doing. For example you can break your expensive rubber nozzles or cameras with inappropriate cleaning. Check: - Piping and joint -
Electronics Forum | Fri Feb 03 10:34:09 EST 2017 | prdmm1
PANASONIC ERJ-12ZYJ203U i am having a lot of problems picking this resistor up. i have purchased a new tool per engineering (NOT the problem). it seems the my9 is picking up then dropping it. then the machine goes to pick another and picks the dropp
Electronics Forum | Wed Nov 16 05:12:36 EST 2011 | bobpan
A couple of things i would try: 1. Does function 30 give you a nozzle height that is repeatable. The number should be around 200.....+/- 20 or so. 2. I would change the z-rod because the spring could be worn out and when the vacuum turns on....it ca
Electronics Forum | Wed Sep 10 07:42:52 EDT 2008 | lloyd
Can you provide a bit more info on your machine setup. I not full fimilar with the S-27 so a few points may not be relevant to your machine. Are you using Siplace Pro. Are you using the standard GF for the 0201 component. Do you have the component
Electronics Forum | Mon May 06 16:34:20 EDT 2019 | tey422
First of all, I am not familiar with the machine you stated. But there is something you should check out. That is if the nozzle tips having solder paste stick to it or not. If nozzle tips having a fresh paste stick to it, the component might not a
Electronics Forum | Tue Jul 14 13:45:04 EDT 2009 | christian01976
Hello! You could check your pick an mount vacuum, too. You can do it in COMPONENT INFO with the ADJUST ASSISTANT (F6). Then PICK UP COMPONENT. If you don´t know how to read the grafic that is shown then just push F1 for HELP. What size do the TANT h
Electronics Forum | Thu Jan 11 19:52:55 EST 2024 | travishemen
Check the top of the placing head. There are 3 screws around a piece that pops up when you push up on the nozzle. I had one once that was vibrating and causing the part to place slightly off angle. It is exposed to the vacuum used to pick the part
Electronics Forum | Mon Oct 13 09:22:14 EDT 2014 | rgduval
Deni, Thanks. I managed to do pretty much exactly that. I was able to get the changers to pop up, and check the vacuum on the nozzles. The first two nozzles are very well sealed into the changer (can't move them), but, the balance of the nozzles
Electronics Forum | Thu Feb 24 06:11:18 EST 2005 | siverts
Nozzle used? Nozzle tip damaged/worn-out (that's where the nozzle life comes in)? Component package? Heavy component? Feeder? Do You see that component type, used by that nozzle inside the machine, or components at the wrong spot on the pcb? If so, t
Electronics Forum | Sun Oct 04 08:07:53 EDT 1998 | jvo
| I am experiencing solder paste comtaminatin of nozzels on 0603 size components resulting in missing components. The machine is failing to alarm under these circumstances. Has anybody else experienced this problem & found a solution? | Check if you
