Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
Electronics Forum | Wed Sep 13 03:25:43 EDT 2017 | sbar5781
Any insight appreciated!
Electronics Forum | Fri Sep 08 21:49:24 EDT 2017 | sbar5781
Hello, I have a few PCB boards i am trying to be manufactured that are miniaturized medical devices. Thus they require IPC Class 3 Specs. However as miniature devices they have limited space, including a 0.4mm pitch BGA socket, which currently has
Electronics Forum | Mon Oct 09 06:16:31 EDT 2017 | jamesbarnhart
I think you needed an IPC Class 3 annular ring because for very dense designs, the smaller the annular ring the better, as less space is taken by the pad or via and more space can be dedicated to routing the traces in highly populated areas of the bo
Electronics Forum | Fri May 29 08:34:02 EDT 1998 | John Ryder
Dennis, Consider that only Philips can offer complete flowline solutions and equipment to satisfy any requirement, from low volume through high. Check out our website at www.philips-ia.com or call 1-800-4-PHILIPS =JR=
Electronics Forum | Fri May 15 09:09:50 EDT 1998 | Earl Moon
| We are just starting out with SMT. I need any and all the information you have. We are looking to start a small to mid range line. I provide consultation for these requirements. Please contact if interested. Sincerely, Earl Moon pod@ix.netcom.com
Electronics Forum | Wed Sep 12 20:50:26 EDT 2001 | davef
Look at "DPMO: A Tool For Achieving World-Class Process Quality" Charles-Henri Mangin, SMT magazine, 8/00, p 77-78
Electronics Forum | Fri May 22 15:39:59 EDT 1998 | serge
good morning sir i m Belgium and i was responsable for SMT training and maintenance for Alcatel do you believe that i can help you??? | We are just starting out with SMT. I need any and all the information you have. We are looking to start a sma
Electronics Forum | Mon May 04 21:35:25 EDT 1998 | Dave F
| We are just starting out with SMT. I need any and all the information you have. We are looking to start a small to mid range line. Denis, You should pursue the following SMTNet thread on this topic: Posted by Igor Kostyuk on April 22, 1998 at 16:57
Electronics Forum | Tue May 05 13:44:57 EDT 1998 | Mark Mitchell
Mr. Desrochers; Philips EMT Americas offers a three day course entitled, "Introduction to SMT Manufacturing". The course addresses all major factors that influence the automated SMT assembly process. Topics that are discussed in the course are list