Electronics Forum | Tue Nov 30 17:32:37 EST 2004 | russ
If you are lucky, you might be able to chip the solder off the fingers with an Exacto knife and then polish it up with a pink eraser. This does work if the solder on the fingers isn't wetted very well. Russ
Electronics Forum | Thu Sep 09 10:50:59 EDT 2004 | agkettle
Does anyone have any experience with underfill of HD connectors? New customer wishes to underfill 6 HD connectors that have been pressed into PCB. Capillary action is causing the conformal coat to wick up into connector. Material is acrylic.
Electronics Forum | Thu Aug 22 23:09:34 EDT 2019 | sssamw
Yes, you need work with supplier to see if can run pin in paste for these connectors, even do some experiments. A step-up stencil would be good for these connectors, also connectors pin size and length match with PCB hole design.
Electronics Forum | Tue Dec 28 09:36:34 EST 1999 | Dan Woodward
Certainly automatic placement, preferably with vision system assistance will yield a more repeatable process. Process repeatability (paste deposition, connector placement, reflow cycle, etc.) will be your key to success here. Another possibility yo
Electronics Forum | Thu Dec 30 10:56:08 EST 1999 | Dan Woodward
Hi Dave, ASG in Florida (www.goasg.com) manufactures machines specifically to pick and place pressfit connectors, including vision inspection of the pins. They also manufacture a line of electric servo presses for pressfit connectors. I would be hap
Electronics Forum | Tue Dec 11 11:59:00 EST 2012 | sarason
The issue is surface tension around the connector. Your tip needs to have more surface tension than the pins of the connector as it forms a cluster when being soldered. When I used to solder superfine connectors with a metcal iron it had a horses hoa
Electronics Forum | Mon Dec 10 13:26:40 EST 2012 | dyoungquist
We are using our selective solder machine to solder a backplane with sixteen (16) 4x48 pin 0.080" connectors. Our first pass yield is about 85% meaning that 85% of the connectors come out with no bridges. Not quite as fine pitch as your connector a
Electronics Forum | Fri Dec 07 13:31:09 EST 2012 | kenkay
We had a similar issue and it was fixed by trimming the connector so there was barely enough lead protrusion through the board to show a discernible lead. We had to get a special plate and small machine to cut the connectors, but we haven’t had a bri
Electronics Forum | Wed May 23 10:12:32 EDT 2001 | richf
We're close to receive an assy including one VHDM connector, I'd like to receive any info to be able to place this part properly, and if possible, to know if there is any automatic equipment to place them
Electronics Forum | Wed Dec 29 18:28:12 EST 1999 | Dave
Does anyone have information on any automatic machines that place pressfit connectors (manufacturers, cost, websites, etc.)?