Electronics Forum | Fri May 30 09:53:19 EDT 2008 | cyber_wolf
"Another sticky issue is that if you use after market nozzles especially mixed in with Fuji nozzles the Anti-Marking Illumination Disks can be different enough that the vision system will reject nozzles. Jerry " Thats what I meant when I said they
Electronics Forum | Fri May 30 10:18:34 EDT 2008 | jdengler
I've had some that under normal light they looked the same but when the UV light hit them they were very different.
Electronics Forum | Fri May 30 11:58:16 EDT 2008 | fredc
The right paper incorrectly applied can be a problem also. I have seen it on even new Fuji nozzles with the illumination disk bunched up on one side of the tube with a gap on the opposite side.
Electronics Forum | Fri Feb 25 16:34:53 EST 2005 | jimmyb
In your PDs you must specify a single nozzle size. Meaning don't assume that entering nozzle size max=1.3 and nozzle size min=1.3 forces the machine to use a 1.3. Nozzle size min is not used in the CP6 software (it only uses nozzle size max), there
Electronics Forum | Thu Feb 24 12:08:15 EST 2005 | siverts
Checked the condition of your nozzles? Vacuum ok? Dummy part picked from the same feeder position? Dummy part picked from the very same feeder? How often does this problem occur? How many dummys did you pick for comparison? Sometimes a feeder calibr
Electronics Forum | Fri May 30 08:24:08 EDT 2008 | cyber_wolf
The nozzles get centered at zero degrees and 180 degrees. I believe the yellow asterisk is the measurement at zero degrees, when it rotates to 180 is when you will get a red X or a green O. (In other words the yellow asterisk is normal) I think you
Electronics Forum | Thu Aug 05 20:37:22 EDT 2004 | Haran
Pls advise how the part thickness affects the placement for Chip Shooter like CP6.
Electronics Forum | Thu May 29 14:57:26 EDT 2008 | rodrigo
Hi all, Is it normal for some of the small nozzles to be rejected by the wide view camera? Every time I do a nozzle centering the narrow view camera shows green circles for nozzles 1,2,3,4. The larger ones (5 and 6) show the asterisk. The wide view c
Electronics Forum | Tue Mar 23 18:02:54 EDT 2010 | rodrigo
Hi all, We're setting up a cp-65 and we're finding some issues with it. It has a missing 1st solenoid/switch and some nozzle valves on the cam. The biggest issue is this C axis servo error. The proper data was set to a cam speed of 250 (25%). That's
Electronics Forum | Wed Jun 21 09:23:28 EDT 2006 | rmitchell
problem solved. Some PCB table support pins were jammed down in the table preventing the Z axis from lowering all the way. The intial error mesage was x and y servo, but the real error was the z axis overflow. Rob